Feeding Options - Canon IMAGE FORMULA DR-3010C User Manual

Feeding Options

This section describes the procedure for selecting the method for feeding
documents.
Click the [Others] tab in the Properties for Canon DR-3010C dialog box →
select the document feeding method from the Feeding Option
drop-down list → click [OK].
NOTE
•
Details of each feeding method are indicated below.
[Standard Feeding]
This feeding method is good for scanning small batches of documents that are
placed one batch at a time. Scanning stops when the documents have been
scanned.
[Panel-Feeding]
This feeding method is good for scanning batches of documents of different
sizes. After placing the documents, press the Start button on the Scan Panel to
start scanning, and press the assigned Stop button to stop scanning.
When scanning documents with different sized pages, after placing the
documents, you can adjust the document guide position.
[Automatic Feeding]
This feeding method is good for scanning batches of the same sized
documents. Scanning starts when the scanner detects the placed documents,
and stops when you press the Stop button.
53
When [Automatic Feeding] is selected, the Setting button is enabled to
allow setting the delay time from when a placed document is detected to
when scanning starts. The delay time can be set from 0 to 60 seconds.
Batch Separation (ISIS driver only)
When the separation timing to use when scanning starts with batch separation
enabled in the application. (If [Standard Feeding] is selected, batch separation
is disabled.)
[Auto]
Document batches are separated automatically.
[Panel]
Document batches are separated when [Batch Separation] on the Scan Panel is
pressed. (See "Using the Scan Panel," on p.30.)
DR-3010C
DR-3010C