Boutside Back Exhaust; Outside Back Exhaust; Wall Plate; Back Exhaust - GE JVM1631 Installation Instructions Manual

B

OUTSIDE BACK EXHAUST

INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Exhaust Adaptor to

Wall Plate

B3. Attach Mounting Plate
to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Oven
PREPARING THE REAR WALL
B1.
FOR OUTSIDE BACK EXHAUST
F
H
1
Place the mounting plate against the rear wall and
align it with the holes drilled earlier.
2
Using a pencil, put dots through holes/notches F,
G, H and I (see above illustration). Remove the
mounting plate and draw lines extending through
the points. This will give the location and size of the
box cutout for the rear wall duct.
3
Use a saw (saber or keyhole) to cut out the opening.
Installation Instructions
G
I
15
(Horizontal Duct)
ATTACH THE EXHAUST
B2.
ADAPTOR TO THE WALL PLATE
1
Unscrew and remove the exhaust adaptor
assembly from the top of the oven.
Attach the exhaust adaptor to the back of the
2
wall plate by sliding it into the guides at the top
center of the back of the plate.
Exhaust Adaptor
Slide exhaust
adaptor into
guides on
wall plate.
Guide
Push in securely until it is in the lower locking
tabs. Take care to assure the damper hinge is
installed so that it is at the top and that the
damper swings freely.
Exhaust
Adaptor
Damper
(hinge side up)
Guide
Locking
Tabs