Light Bulb Replacement; Cooktop Light - GE JVM1530DM Owner's Manual

Light Bulb Replacement

Cooktop Light

Replace the burned-out
bulb with a 120 volt,
40-watt incandescent
bulb (WB36X10003),
available from your
GE supplier.
Oven Light
Replace the burned-out
bulb with a 120 volt,
40-watt incandescent
bulb (WB36X10003),
available from your
GE supplier.
1 To replace the oven light,
first disconnect the power
at the main fuse or circuit
breaker panel or pull
the plug.
2 Remove the front grille by
backing out the 3 screws
along the top. Slide the
grille to the left, then pull
straight out.
1 To replace the bulb, first
disconnect the power at
the main fuse or circuit
breaker panel or pull
the plug.
2 Remove the screw from
light cover and lower
the cover.
Remove Screw
3 Remove the charcoal
filter, if present. Reach
into the opening, just
right of center. The light
bulb is located beneath
a light compartment
cover. Press and hold
the center snap while
lifting the tab on the
left corner. Remove the
cover. Remove the bulb
by turning gently.
3 Be sure the bulb is cool
before removing. After
breaking the adhesive
seal, remove the bulb by
gently turning.
4 Replace the bulb. Close
the light cover and
secure the cover with the
screw. Connect electrical
power to the oven.
4 Install the replacement
bulb. Reinstall the
compartment cover and
charcoal filter, if present,
Reinstall the front grille
panel with the 3 original
screws.
Interior Light
Housing
5 Connect electrical power
to the oven.
33