Siemens KW36K Series User Manual page 52

en Troubleshooting
Fault
A warning signal
sounds and
flashes in the temper-
ature display.
A warning signal
sounds and
in the temperature dis-
play.
The temperature dif-
fers greatly from the
setting.
The base of the wine
storage compartment
is wet.
The appliance hums,
bubbles, buzzes,
gargles or clicks.
The appliance makes
noises.
52
Cause and troubleshooting
The exterior ventilation grilles are blocked.
Remove any obstructions from in front of the exter-
▶
ior ventilation grilles.
It was too cold in the wine storage compartment for
flashes an extended period.
Press any touch field.
▶
Note:
again.
Different causes are possible.
Switch off the appliance. → Page 47
1.
Switch the appliance back on after five minutes.
2.
→ Page 47
If the temperature is too warm, check the temper-
‒
ature again after a couple of hours.
If the temperature is too cold, check the temper-
‒
ature again on the following day.
The condensation channel or drainage hole are
blocked.
Clean the condensation channel and the drainage
▶
hole. → Page 50
Not a fault. A motor is running, e.g. refrigerating unit,
fan. Refrigerant flows through the pipes. The motor,
switches or solenoid valves are switching on or off.
No action required.
The appliance is not level.
Align the appliance using a spirit level and the
▶
screw feet.
The appliance is not free-standing.
Observe the minimum clearances for the appliance.
▶
Fittings wobble or stick.
Check the removable fittings and, if required, re-
▶
place these.
flashes until the set temperature is reached