Rear - Canon imageFORMULA DR-7090C Reference Manual

Rear

a Air Vents
b USB Connector
Connect a Hi-Speed USB 2.0 compatible USB cable here.
c DIP Switches
Configure these switches to specify the SCSI ID or
terminator ON or OFF.
d SCSI Connectors
Connect a SCSI cable (50-pin half pitch, pin type) here.
e Power Cord Connector
Connect the provided power cord here.
CAUTION
• Never touch the cables at the rear of the scanner. Disconnection
of these cables can cause a malfunction of the scanner.
• Take care to ensure that the vents never become blocked.
Blocked vents can lead to heat build-up inside of the scanner and
create the risk of fire.
12
■ Setting the SCSI ID and terminator
Set the SCSI ID and terminator using the DIP switches
located between the SCSI connectors and power cord
connector.
For details on the settings, refer to the User Manual.
SCSI ID
1 2 3 4
SCSI ID SW1
0 OFF
1 ON
2 OFF
3 ON
4 OFF
5 ON
6 OFF
7 ON
Refer to the table when setting the SCSI ID. If other SCSI
devices are connected to or built into the computer, make
sure that none of the SCSI IDs overlap.
IMPORTANT
• The SCSI ID is factory set to 2.
• You can set the SCSI ID between 0 and 7. However, do not
use ID 7 as this ID is usually assigned to the SCSI controller.
In addition, when the SCSI hard disk drive is built in, do not
use IDs 0 and 1 as these IDs are usually assigned to the hard
disk.
Terminator
SW2 SW3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON