Advertisement
HOW TO OPERATE
FILLING WITH WATER
1.
Pull Water Tank Cap back.
2.
Fill water tank until the water level reaches the max line (150 ml).
WARNING: To avoid water sprayed out when in use,
please do not fill water over the "Max" level.
3.
Push the Water Tank Cap back into place.
4.
When refilling, please unplug unit first and allow steamer to cool for 5 minutes
before adding more water. CAUTION: Steamer will be hot after use.
IRONING INSTRUCTION
1.
Lay garment out on a flat, smooth surface. Make sure
there is no pulled fabric before using.
2.
Once water tank is filled, plug in the steamer, turn switch to mode you'd like (STEAM
or IRON) and wait for it to heat up. Steamer will take 50 seconds before steam comes
out, then it's ready for use. NOTE: Steamer will run continuously for 8 minutes.
3.
Use one hand to hold the fabric and the other to steam. Using a slight back-and-
forth vertical motion over the area you are steaming will enhance the cleaning
process, as will scrubbing the area. NOTE: Use the included Fabric Brush for tough
stains. Install before using because steam will be hot. DO NOT tilt the steamer.
4.
When finished, turn switch to OFF and let cool.
5.
Wipe steamed areas with a clean cloth to remove loosened dirt and grime.
CAUTION: When using the steamer, please make sure the water level does not
exceed the maximum water level. Excess water may result in water leakage
and water spraying. To operate the steamer again when it stops leaking water.
Before disassembling the appliance or attaching accessory to nozzle, please
make sure the steamer is completely cooled down (approximately 30 mins).
6
Advertisement
