3)
Use a network cable to connect the Ethernet port to the powered device
(T) or Ethernet switch (R). Connect the UTP port of the transmitter to
the receiver and use a grounding wire to connect the grounding terminal.
4)
Check that the installation is correct and power on the device to be sure
it is operating normally.
Troubleshooting
Please refer to the following information if the device does not work:
Confirm the installation is done according to factory installation
⚫
requirements.
⚫
Confirm if the RJ45 cable order is following the EIA/TIA568A or 568B
industry standards.
The maximum transmission distance depends on the signal source and
⚫
cable quality. Please do not exceed the maximum transmission distance.
Please replace the failed device with a known working unit to determine
⚫
if you have a damaged or faulty unit.
If the problem persists, please contact your nearest KBC office or dealer.
⚫
Need Help?
Please visit our website
office or dealer.
www.kbcnetworks.com
Page 8 of 8
or contact your nearest KBC