Advertisement
Getting started
Hooking up the speaker
Connect the supplied AC power adaptor to the speaker.
To wall outlet
AC power adaptor (supplied)
Hooking up the transmitter
Connect the transmitter to the dock connector port of an
iPod firmly.
Listening to sound
1
Press the 1 (power) button of the
speaker to turn it on.
The power indicator (green) of the speaker lights
up.
(rear)
To DC IN 12 V
jack
Dock connector
port (30 pin)
Power button
1 (power) button
2
Press the power button of the transmitter
for about 1 second to turn it on, or start
playback on the iPod.
The indicator of the transmitter flashes twice
(Playback will start automatically).
When the Bluetooth connection is made
properly, both the power indicator (green) and
communication status indicator (blue) of the
speaker light up indicating that pairing is
completed.
Notes
• If the Bluetooth connection is not established within about 5
minutes. The transmitter automatically turns itself off. In
this case, start over from step 2.
• If playback cannot start automatically, try to start playback
on the iPod.
• If the source device has a bass boost function or equalizer
function, set them to off. If these functions are on, sound
may be distorted.
3
Adjust the volume.
Press the VOLUME + or - button on the speaker.
Note
A beep sounds when the volume is set to minimum or
maximum.
To finish listening
Terminate the Bluetooth connection by any of the
operations below.
• To turn off the transmitter, press and hold the transmit-
ter's power button for about 1 second. The indicator of
the transmitter flashes once and the power turns off.
• To turn off the speaker, press and hold the speaker's 1
(power) button for about 1 second. The power indicator
of the speaker goes off.
• Turn off the iPod.
Advertisement
