Samsung AM FNTD Series User Manual page 16

Using the remote controller
Inserting the batteries
1. Open the battery cover of the remote controller.
Press the ( ) part gently and lift it up in the arrow direction.
2. Insert the batteries.
Check and match the (+)and (-) signs accordingly.
3. Close the battery cover.
Match the cover and bottom part of the remote controller and press it until you hear
click sound.
Make sure that water is not allowed to enter the remote controller.
CAUTION
• There is a possibility that the air conditioner will not operate by remote controller near strong light such
as a fluorescent lamp or neon sign. In this case, use the remote controller in front of the remote controller
NOTE
receiver of the indoor unit.
• If other electrical products are operated by the remote controller, call your nearest service center.
• Filter reset : When the filter reset indicator is turned on the indoor unit display, clean the filter and press
• Beep off : To silence the beep sound, press the Settings  <, > or Settings  (Beep) blinking  SET
button. If you press the Settings  <, > or Settings  (Beep) blinking  SET button again,
the beep sound will ring again.
(Applicable in countries with separate collection systems)
This marking on the battery, manual or packaging indicates that the batteries in this product should not be
disposed of with other household waste at the end of their working life. Where marked, the chemical symbols
Hg, Cd or Pb indicate that the battery contains mercury, cadmium or lead above the reference levels in EC
Directive 2006/66. If batteries are not properly disposed of, these substances can cause harm to human health
or the environment.
To protect natural resources and to promote material reuse, please separate batteries from other types of
waste and recycle them through your local, free battery return system.
16
the Settings  <, > or Settings  (Filter Reset) blinking  SET button.
Correct disposal of batteries in this product