Using The Override Button; Viewing Only Connected Wifi Or Vennet Sensor Values; Viewing And Adjusting Humidity Values - Venstar T4950-IAQ Owner's Manual And Installation Instructions

How to use your thermostat

Using the Override Button

UNOCCUPIED OPERATION -
During programmed, unoccupied
periods, pressing the OVERRIDE button will force the thermostat into Occupied
1 settings for 30 minutes. Each press of the OVERRIDE button will add another
30 minutes of time for up to 4 hours. If the maximum time has been set,
the next press of the OVERRIDE button will reset the timer and return the
thermostat to the correct time period program for the day
OCCUPIED OPERATION - During programmed, occupied periods, pressing the
OVERRIDE button will force the thermostat into an unoccupied period for the
rest of the day. During this forced unoccupied period the OVERRIDE button will
operate as described above.

Viewing only connected wifi or VenNet sensor Values

You may also view connected wifi and VenNet sensor values after pressing
ACCESSORY STATUS followed by COOLER button. Use MODE button to cycle
between readings. Note that battery strength of the battery powered sensors
can be viewed on these screens. Press ACCESSORY STATUS again to return to
normal operation.

Viewing and adjusting humidity Values

Press the HUMIDITY button. The current indoor relative humidity and daily
min/max values are shown. If you wish to alter either the humidification
or dehumidification setpoints, press MODE to cycle between screens and
WARMER/COOLER to adjust the settings. Press HUMIDITY again to return to
normal operation.
NOTE: Override may only be
used when the thermostat is
set to PROGRAM ON.
OVERRIDE
OUTDOOR
ACCSRY
HUMIDITY
9