Table of Contents
Advertisement
1-9: DVD MT PCB/DVD DECK (Refer to Fig. 1-9)
1.
Short circuit the position shown in Fig. 1-9 using a
soldering iron. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Remove the 4 screws 1.
2.
3.
Remove the DVD Top in the direction of arrow (A).
Remove the 4 screws 2.
4.
5.
Remove the DVD Deck in the direction of arrow (B).
6.
Disconnect the following connectors:
(CP2301, CP2302 and CP2303).
Remove the 2 screws 3.
7.
8.
Remove the DVD MT PCB in the direction of arrow (C).
Remove the screw 4.
9.
Remove the 3 screws 5.
10.
11.
Remove the Deck Angle in the direction of arrow (D).
1
1
3
DVD MT PCB
2
(C)
2
DVD Deck
2
5
(B)
4
5
(D)
All manuals and user guides at all-guides.com
DISASSEMBLY INSTRUCTIONS
DVD Top
1
1
(A)
3
CP2303
CP2302
Pick Up PCB
CP2301
2
Short circuit using a
5
soldering iron.
Deck Angle
Fig. 1-9
NOTE
1.
Before your operation, please read "PREPARATION OF
SERVICING".
2.
Use the Lead Free solder.
3.
Manual soldering conditions
• Soldering temperature: 350 ± 5˚C
• Soldering time: Within 2 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4.
When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux smoke
away from it.
5.
When installing the DVD Deck, remove all the soldering on
the short circuit position after the connection of Pick Up
PCB and DVD PCB connector.
1-10: POWER PCB (Refer to Fig. 1-10)
Remove the 3 screws 1.
1.
2.
Disconnect the following connectors:
(CP1707 and CP1710).
3.
Remove the POWER PCB in the direction of arrow.
B1-3
1
1
Power PCB
CP1707
1
CP1710
Fig. 1-10
Advertisement
Table of Contents
