Table of Contents
Advertisement
Y
Pr
Pb
L
R
H eadp hone
D VI Audio I N
YPbPr
out
Audio In
Component ports on the TV
Video output ports on DVD player
DTV connection
This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However,
if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents
(480p,720p,1080i).
Y
Pr
Pb
DVI Audi o IN
Audi o In
Digital Set-top Box
All manuals and user guides at all-guides.com
How to connect
1. Connect the DVD video outputs (Y, Pb/Cb, Pr/Cr) to the Y, Pb, Pr
jacks on the TV and connect the DVD audio outputs to the YPbPr
Audio IN jacks on the TV, as shown in the figure.
L
R
2. If your DVD only has an S-VIDEO output jack, connect this to
S-Vid eo
CVBS
S-Vid eo/ CVBS
Aud io In
the S-VIDEO input on the TV. as shown in the figure.
NOTE: If your DVD player does not have component video output,
use S-Video.
How to use
1. Turn on the DVD player, insert a DVD.
2. Use the INPUT button on the remote control to select YPbPr
mode.
3. Press Play button on external equipment for program play.
4. Refer to the DVD player's manual for operating instructions.
■ Component Input ports
To get better picture quality, connect a DVD player to the
componentinput ports as shown below.
Y
Pb
Y
Pb
Y
B-Y
Y
Cb
Y
P
Β
How to connect
Use the TV`s (Y, PB, PR) , VGA or HDMI jack for video
connections, depending on your set-top box connector.
L
R
YPbPr
Headp hone
HDMI
Opti cal
Audi o In
out
Then, make the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner`s
manual for the digital set-top box.)
2. Use INPUT on the remote control to select YPbPr, VGA,
or HDMI source.
23
Pr
Pr
R-Y
Cr
P
R
Signal
YPbPr
HDMI/DM
480i
Yes
Yes
480p
Yes
Yes
720p
Yes
Yes
1080i
Yes
Yes
Advertisement
Table of Contents
