Advertisement
Quick Links
1. Introduction
The EV-RM30 is a TPMS receiver box with RS-232 Interface designed
to integrate the TPMS solution with the Mobile DVR. The EV-RM30
can transmits matched TPMS sensors' signal, allows matching TPMS
Sensor ID through Bluetooth or BTU.
2. Packing List
•
EV-RM30 x 1
•
10m antenna extension cable
•
Adhesive lined polyolefin tubing
3. Specification
Model Name
Wireless Range
Interface
Frequency
Operation Voltage
Operation Current
Operating Temperature
Dimensions
4. Installation
1. Connect the power cable to the 9 ~ 36V battery power, red wire
to ACC power and black wire to GND, orange TX wire to the RX
wire of the Mobile DVR, white RX wire to the TX wire of the
Mobile DVR.
•
Quick Installation Guide x 1
•
Cable tie
•
Cable holder
EV-RM30
20m
RS-232
433.92MHz
9 ~ 30VDC
40mA
-40°C ~ 85°C / -40°F ~ 185°F
97.9 x 58 x 17mm / 3.85" x 2.28" x 0.66"
EV-RM30
Advertisement
Summary of Contents for EverFocus EV-RM30
- Page 1 EV-RM30 1. Introduction The EV-RM30 is a TPMS receiver box with RS-232 Interface designed to integrate the TPMS solution with the Mobile DVR. The EV-RM30 can transmits matched TPMS sensors’ signal, allows matching TPMS Sensor ID through Bluetooth or BTU.
- Page 2 EV-RM30 2. Connect the antenna cable with the supplied 10m antenna extension cable. 3. Wire the antenna extension cable along the vehicle’s body wiring to the chassis that near the rear wheels. Antenna Extension Cable Tie Cable 4. Fix the antenna using the supplied Cable tie. Do not twist the antenna cable and make sure the antenna does not touch any metal parts.
- Page 3 EV-RM30 5. For closed chassis, fix the antenna using the supplied Cable holder. When use screws to fix the Cable holder on the chassis, make sure to prepare screws of proper length in avoiding damage of the oil tank. Cable...