Advertisement
USING THE UNIT SAFELY
About
WARNING and
CAUTION Notices
About the Symbols
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
Used for instructions intended to alert the
user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic animals
or pets.
ALWAYS OBSERVE THE FOLLOWING
WARNING
WARNING
To completely turn off power to the unit, pull
Do not allow foreign objects or liquids to
out the plug from the outlet
enter unit; never place containers with liquid
on unit
Even with the power switch turned
off, this unit is not completely
Do not place containers containing
separated from its main source
liquid (e.g., flower vases) on this
of power. When the power needs
product. Never allow foreign
to be completely turned off, turn off the
objects (e.g., flammable objects,
power switch on the unit, then pull out the
coins, wires) or liquids (e.g., water
plug from the outlet. For this reason, the
or juice) to enter this product.
outlet into which you choose to connect
Doing so may cause short circuits,
the power cord's plug should be one that is
faulty operation, or other malfunctions.
within easy reach and readily accessible.
Turn off the unit if an abnormality or
Do not disassemble or modify by yourself
malfunction occurs
Do not carry out anything unless
Immediately turn the unit off,
you are instructed to do so in the
remove the AC adaptor from the
owner's manual. Otherwise, you
outlet, and request servicing by
risk causing malfunction.
your retailer, the nearest Roland
Service Center, or an authorized Roland
Do not repair or replace parts by yourself
distributor, as listed on the "Information"
Refer all servicing to your retailer,
when:
the nearest Roland Service
• The AC adaptor or the power cord has
Center, or an authorized Roland
been damaged; or
distributor, as listed on the
• If smoke or unusual odor occurs; or
"Information. "
• Objects have fallen into, or liquid has
been spilled onto the unit; or
Do not use or store in the following types of
locations
• The unit has been exposed to rain (or
otherwise has become wet); or
• Subject to temperature
extremes (e.g., direct sunlight
• The unit does not appear to operate
normally or exhibits a marked change in
in an enclosed vehicle, near a
performance.
heating duct, on top of heat-
generating equipment); or are
Be cautious to protect children from injury
• Damp (e.g., baths, washrooms,
Always make sure that an adult is
on wet floors); or are
on hand to provide supervision
• Exposed to steam or smoke; or are
and guidance when using the
• Subject to salt exposure; or are
unit in places where children are
• Exposed to rain; or are
present, or when a child will be using the
• Dusty or sandy; or are
unit.
• Subject to high levels of vibration and
Do not drop or subject to strong impact
shakiness.
Otherwise, you risk causing
Do not place in an unstable location
damage or malfunction.
Otherwise, you risk injury as the
result of the unit toppling over or
Do not share an outlet with an unreasonable
dropping down.
number of other devices
Use only the supplied AC adaptor and the
Otherwise, you risk overheating
correct voltage
or fire.
Be sure to use only the AC adaptor
supplied with the unit. Also,
Do not use overseas
make sure the line voltage at the
Before using the unit in overseas,
installation matches the input voltage
consult with your retailer, the
specified on the AC adaptor's body. Other
nearest Roland Service Center, or
AC adaptors may use a different polarity, or
an authorized Roland distributor,
be designed for a different voltage, so their
as listed on the "Information. "
use could result in damage, malfunction,
or electric shock.
Do not bend the power cord or place heavy
CAUTION
objects on it
Otherwise, fire or electric shock
Place in a well ventilated location
may result.
The unit and the AC adaptor
should be located so their location
or position does not interfere with
their proper ventilation.
IMPORTANT NOTES
Power Supply
• Do not connect this unit to same electrical
outlet that is being used by an electrical
appliance that is controlled by an inverter
The
symbol alerts the user to important instructions or
or a motor (such as a refrigerator, washing
warnings.The specific meaning of the symbol is
machine, microwave oven, or air conditioner).
determined by the design contained within the triangle. In
Depending on the way in which the electrical
the case of the symbol at left, it is used for general
appliance is used, power supply noise
cautions, warnings, or alerts to danger.
may cause this unit to malfunction or may
The
symbol alerts the user to items that must never be
produce audible noise. If it is not practical
carried out (are forbidden). The specific thing that must
to use a separate electrical outlet, connect a
not be done is indicated by the design contained within
power supply noise filter between this unit
the circle. In the case of the symbol at left, it means that
and the electrical outlet.
the unit must never be disassembled.
• The AC adaptor will begin to generate heat
The
symbol alerts the user to things that must be
after long hours of consecutive use. This is
carried out. The specific thing that must be done is
normal, and is not a cause for concern.
indicated by the design contained within the circle. In the
case of the symbol at left, it means that the power-cord
• This unit is equipped with a protection
plug must be unplugged from the outlet.
circuit. A brief interval (a few seconds)
after turning the unit on is required
before it will operate normally.
Placement
CAUTION
• This unit may interfere with radio and
television reception. Do not use this unit in
When disconnecting the power cord, grasp it
the vicinity of such receivers.
by the plug
• Noise may be produced if wireless
To prevent conductor damage,
communications devices, such as cell
always grasp the power cord by its
phones, are operated in the vicinity of this
plug when disconnecting it from
unit. Such noise could occur when receiving
this unit or from a power outlet.
or initiating a call, or while conversing.
Should you experience such problems, you
Periodically clean the power plug
should relocate such wireless devices so
An accumulation of dust or foreign
they are at a greater distance from this unit,
objects between the power plug
or switch them off.
and the power outlet can lead to
• When moved from one location to
fire or electric shock.
another where the temperature and/or
At regular intervals, be sure to pull out the
humidity is very different, water droplets
power plug, and using a dry cloth, wipe
(condensation) may form inside the unit.
away any dust or foreign objects that may
Damage or malfunction may result if you
have accumulated.
attempt to use the unit in this condition.
Therefore, before using the unit, you must
Disconnect the power plug whenever the
allow it to stand for several hours, until the
unit will not be used for an extended period
condensation has completely evaporated.
of time
• Do not place containers or anything else
Fire may result in the unlikely event
containing liquid on top of this unit. Also,
that a breakdown occurs.
whenever any liquid has been spilled on the
surface of this unit, be sure to promptly wipe
Route all power cords and cables in such a
it away using a soft, dry cloth.
way as to prevent them from getting
Additional Precautions
entangled
Injury could result if someone were
• Use a reasonable amount of care when
to trip on a cable and cause the
using its jacks and connectors. Rough
handling can lead to malfunctions.
unit to fall or topple.
• When disconnecting all cables, grasp the
Avoid climbing on top of the unit, or placing
connector itself—never pull on the cable.
heavy objects on it
This way you will avoid causing shorts, or
Otherwise, you risk injury as the
damage to the cable's internal elements.
result of the unit toppling over or
• When you need to transport the unit,
dropping down.
pack it in shock-absorbent material.
Never connect/disconnect a power plug if
Transporting the unit without doing
so can cause it to become scratched or
your hands are wet
damaged, and could lead to malfunction.
Otherwise, you could receive an
electric shock.
Copyrights/Licenses/Trademarks
Disconnect all cords/cables before moving
• MMP (Moore Microprocessor Portfolio)
the unit
refers to a patent portfolio concerned
Before moving the unit, disconnect
with microprocessor architecture, which
the power plug from the outlet,
was developed by Technology Properties
Limited (TPL). Roland has licensed this
and pull out all cords from external
devices.
technology from the TPL Group.
• Roland is an either registered trademark
Before cleaning the unit, disconnect the
or trademark of Roland Corporation in the
power plug from the outlet
United States and/or other countries.
If the power plug is not removed
• Company names and product names
from the outlet, you risk receiving
an electric shock.
appearing in this document are registered
trademarks or trademarks of their respective
Whenever there is a threat of lightning,
owners.
disconnect the power plug from the outlet
If the power plug is not removed
from the outlet, you risk receiving
an electric shock.
Keep small items out of the reach of children
To prevent accidental ingestion of
the parts listed below, always keep
them out of the reach of small
children.
• Included Parts: Ferrite core
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit di erent from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment requires shielded interface cables in order to meet FCC class B limit.
Any unauthorized changes or modi cations not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
CAN ICES-3 (B)/NMB-3 (B)
Manufacturer:
Roland Corporation
2036-1 Nakagawa, Hosoe-cho, Kita-ku, Hamamatsu, Shizuoka 431-1304, JAPAN
Importer:
Roland Corporation
ENA 23 Zone 1 nr. 1620 Klaus-Michael Kuehnelaan 13, 2440 Geel, BELGIUM
Manufacturer:
Roland Corporation
2036-1 Nakagawa, Hosoe-cho, Kita-ku, Hamamatsu, Shizuoka 431-1304, JAPAN
Importer:
Roland Europe Group Limited
Hive 2, 1530 Arlington Business Park, Theale, Reading, Berkshire. RG7 4SA United Kingdom
有关产品中所含有害物质的说明
本资料就本公司产品中所含的特定有害物质及其安全性予以说明。
本资料适用于����年�月� 日以后本公司所制造的产品。
环保使用期限
此标志适用于在中国国内销售的电子信息产品， 表示环保使用期限的年数。 所谓环保使用
期限是指在自制造日起的规定期限内， 产品中所含的有害物质不致引起环境污染， 不会对
人身、 财产造成严重的不良影响。
环保使用期限仅在遵照产品使用说明书， 正确使用产品的条件下才有效。
不当的使用， 将会导致有害物质泄漏的危险。
产品中有害物质的名称及含量
有害物质
部件名称
铅 （Pb）
汞 （Hg）
镉 （Cd）
外壳 （壳体）
电子部件 （印刷电路板等）
附件 （电源线、 交流适配器等）
本表格依据SJ/T �����的规定编制。
:
表示该有害物质在该部件所有均质材料中的含量均在GB/T ����� 规定的限量要求以下。
:
表示该有害物质至少在该部件的某一均质材料中的含量超出GB/T �����的限量要求。
（企业可在此处， 根据实际情况对上表中打 "×" 的技术原因进行进一步说明。 ）
For EU Countries
For the USA
DECLARATION OF CONFORMITY
Compliance Information Statement
Model Name :
HT-TX01 / HT-RX01
Type of Equipment :
HDMI Extender
Responsible Party :
Roland Corporation U.S.
Address :
5100 S. Eastern Avenue Los Angeles,
CA 90040-2938
Telephone :
(323) 890-3700
For Canada
For EU Countries
For the U.K.
六价铬
多溴联苯
多溴二苯醚
（Cr （ VI） ）
（PBB）
（PBDE）
For the USA
Advertisement
