Advanced Playback Operations; Locating A Track (Multi-Ams/Auto Play/Memory Play) - Sony TC-WE625 Operating Instructions Manual

Advanced Playback Operations

Advanced Playback Operations
Locating a Track (Multi-AMS/
Auto Play/Memory Play)
You can locate the following/previous tracks within a
range of 30 tracks (Multi-AMS: Automatic Music
Sensor) or the beginning of a tape quickly (Auto Play).
You can even locate a specific point anywhere on a
tape (Memory Play).
RESET
DIRECTION MODE
A a
RELAY
Ø ON ø OFF
PITCH CONTROL
– +
0 / )
Note
Check the direction indicator of the deck you use. When you
locate a track on the reverse side (when ª lights up), press
the button(s) in the parentheses.
To locate
The beginning of the
next or succeeding
tracks
(Multi-AMS)
The beginning of the
current track
(Multi-AMS)
The beginning of the
preceding tracks
(Multi-AMS)
The beginning of a
tape (Auto Play)
A particular point on a
tape (Memory Play)
EN
8
MEMORY RESET
RESET MEMORY A COUNTER B RESET MEMORY
g
RMS AUTO CAL(STARTP) DUBBING A B
RMS/START SET CHECK DISPLAY DECK A DECK B A+B REC HIGH/NORMAL
– RMS + START(DECK BP)
0 (AMS) (AMS) ) 0 (AMS) (AMS) )
ª · ª ·
p p
CLEAR BACK FRONT
DOLBY NR
PAUSE REC MUTE REC OFF ON ON FILTER B C S PAUSE REC MUTE REC
P R r P R r
§ §
ª / · 0 / )
Press
) (or 0) as many times as you
want during playback.
For example, to locate 2 tracks
ahead, press twice.
0 (or )) once during playback.
0 (or )) as many times as you
want during playback.
For example, to locate 2 tracks
behind, press three times.
MEMORY on the deck being used
repeatedly until "M" disappears in
the display. Then press 0 (or ))
while holding down · (or ª).
MEMORY on the deck being used
repeatedly until "M" appears in the
display. Find the point you want,
then press RESET to reset the tape
counter and to memorize the point.
To locate the memorized point and
start playback, press 0 (or ))
while holding down · (or ª).
(Press 0 or ) to stop at "0.00"
(TC-WE825S/WE725 only) or at
"0000" (TC-WE625 only). )
Notes
• The Multi-AMS function may not work correctly if:
— the blank space between tracks is less than 4 seconds
long.
— there is a passage of low frequencies or very low
volume within a track.
— the signal strength of the left and right channels are
very different.
• The Multi-AMS function is inoperative on a deck
whenever the other deck is playing, recording (except
during dubbing), or in pause.
• Even if DIRECTION MODE is set to a, the deck stops
when the current side reaches the end during Multi-AMS
operation.
• The tape counters are reset to "0.00" (TC-WE825S/WE725
AUTO REC LEVEL
5
4 6
3 7
2 8
only) or to "0000" (TC-WE625 only) when you turn off the
1 9
0 10
FADER ARL
tape deck.
π SYNCHRO
PHONES