Sony PCWA-DE30 Troubleshooting Manual page 6

If the computer connected to the Wireless LAN Converter is
running Windows XP, is the Ethernet interface set up to act as a
network bridge?
To confirm that the Ethernet connection is not acting as a network brigde,
proceed as follows:
1 Click Start, and then click Control Panel.
2 In Control Panel, double-click Network Connections. If Network
Connections does not appear, click Switch to Classic View.
3 Confirm that the Ethernet network connection is not acting as a network
bridge.
4 If the Ethernet network connection is configured as a network bridge,
right-click the local area connection icon, and click Remove from Bridge.
If Remove from Bridge does not appear on the shortcut menu, the
Ethernet connection is not acting as a network bridge.
Case 2 - I cannot open the Converter Setup Page
Did the IP Address Setup screen appear?
If communication cannot be established with the current IP address of the
computer connected to the Wireless LAN Converter and the IP address of the
Wireless LAN Converter, the IP Address Setup dialog box appears.
If you click Cancel in this dialog box, the Wireless LAN Converter Setup Page
cannot be displayed.
To set up newly the IP address of the Wireless LAN Converter, proceed as
follows:
1 Click Start, point to Programs (All Programs in Windows XP), point to
Wireless LAN, an then click Converter Setup to restart the Converter
Setup Utility.
2 When the IP Address Setup dialog box appears, verify its contents, and
then click Execute Setup.
The IP address of the Wireless LAN Converter is temporarily changed so
that the computer can open the Wireless LAN Converter Setup Page.
If the computer connected to the Wireless LAN Converter is also connected to another
network, make sure that the new IP address does not duplicate the address of a device
on that network.
When you turn off or restart the Wireless LAN Converter, the IP address reverts to its
original setting.
6