Computer - Sony VGC-RT2SRY User Manual

Computer

What should I do if my computer does not start?
❑ Make sure your computer is securely plugged into a power source and turned on and the power indicator light shows the
power is on.
❑ Disconnect all connected USB devices (if any), and then restart your computer.
❑ Remove any extra memory modules you may have installed since purchase, and then restart your computer.
❑ If your computer is plugged into a power strip or an uninterruptible power supply (UPS), make sure the power strip or UPS
is plugged into a power source and turned on.
❑ If the orange DISPLAY OFF indicator is lit, press the DISPLAY OFF button.
❑ Make sure the brightness and contrast controls are adjusted correctly.
❑ Make sure the computer input is selected. To change the display input, press the HDMI SELECT button on the right of
the computer.
❑ Unplug the power cord. Wait three to five minutes. Plug the power cord again and press the power button to turn on your
computer.
❑ Condensation may cause your computer to malfunction. If this occurs, do not use the computer for at least one hour.
❑ If you add or replace a memory module that is not compatible with your computer, your system may not boot. Before
adding or replacing a memory module, be sure to see Sony Support Information
support web site.
❑ Check that you are using the supplied Sony power cord. For your safety, use only the genuine Sony power cord, which is
supplied by Sony for your VAIO computer.
❑ Make sure your computer is not in Sleep mode by pressing the power button on the computer or the sleep button on the
wireless keyboard. If you press and hold the power button for more than four seconds, your computer will turn off
automatically.
Troubleshooting
(page 206) to visit the appropriate
n 164 N