Renault KADJAR 2021 Vehicle User Manual page 117

FUNCTION STOP AND START
This system enables a reduced fuel
consumption and lower greenhouse
gas emissions.
The system is activated automatically
when the vehicle is started.
While driving, the system stops the
engine (standby) when the vehicle is
at a standstill (traffic jam, traffic lights,
etc).
Conditions for engine
standby
The vehicle has set off from where it
was parked;
For automatic gearboxes:
– gearbox is in position D, M or N;
and
– the brake pedal is depressed (suffi-
ciently hard);
and
– the accelerator pedal is not de-
pressed;
and
– the speed is zero for around
1 second.
The engine remains on standby if posi-
tion P is selected, or if position N is se-
lected with the handbrake engaged and
the brake pedal released.
(1/4)
For manual gearboxes:
– the gearbox is in neutral;
and
– the clutch pedal is released. If the

warning light flashes, this
means that the clutch pedal is not
sufficiently released;
and
– the vehicle speed is less than ap-
proximately 2 mph (3 km/h).
For all vehicles:

Warning light on the instru-
ment panel is lit when the engine is on
standby.
The vehicle equipment remain opera-
tional while the engine is stopped.
If the engine stalls while the system
is in operation, pressing the clutch
pedal right down will start it again.
The ignition must
switched off before leav-
ing the vehicle (please see
the information on "Starting,
stopping the engine" in Section 2).
Keep your vehicle station-
ary when the engine is
on standby (shown by the

warning light
instrument panel).
If the engine is put in
standby, the electronic
parking brake (depending
on the vehicle) is not ap-
plied automatically.
be
on the
2.7