Table of Contents
Advertisement
Table 8. System setup options—Display menu (continued)
Display
Full Screen Logo
Direct Graphics Controller Direct
Output Mode
Table 9. System setup options—Connection menu
Connection
Wireless Device Enable
Enable UEFI Network Stack
Enable UEFI Network Stack
Wireless Radio Control
Control WLAN radio
Table 10. System setup options—Power menu
Power
Battery Configuration
Advanced Configuration
Enable Advanced Battery Charge
Configuration
Peak Shift
Thermal Management
USB Wake Support
Wake on Dell USB-C Dock
Block Sleep
Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
When enabled, all graphics output ports directly to the Graphics Processing
Unit (GPU), bypassing Intel Integrated graphics outputs for HDMI, Thunderbolt,
and mDP ports.
Default: OFF
Enable or disable internal WLAN/Bluetooth devices.
By default, WLAN is selected.
By default, Bluetooth is selected.
When enabled, UEFI networking protocols are installed and available, allowing
pre-OS and early OS networking features to use any enabled NICs. This may be
used without PXE turned on.
Default: ON
Enables to sense the connection of the computer to a wired network and
subsequently disable the selected wireless radios (WLAN and/or WWAN).
Upon disconnection from the wired network, the selected wireless radios are
re-enabled.
Default: OFF
Enables the computer to run on battery during power usage hours. Use the
below options to prevent AC power usage between certain times of each day.
By default Adaptive is selected.
Enables Advanced Battery Charge Configuration from the beginning of the
day to a specified work period. Advanced Battery Charged maximizes battery
health while still supporting heavy use during the work day.
Default: OFF
Enables the computer to run on battery during peak power usage hours.
Default: OFF
Sets cooling fan and processor heat management to adjust system
performance, noise, and temperature.
By default, Optimized is selected.
Enables connecting a Dell USB-C Dock to wake the computer from Standby.
Default: ON
Blocks the computer from entering Sleep (S3) mode in the operating system.
System setup
61
Advertisement
Table of Contents
