Installation - B.S. Service CH105E User Instructions

• The minimum distance between the support surfaces of the cooking
pots on the cooker top and the lowest part of the cooker hood must be
at least 65 cm. If a connection tube composed of two parts is used, the
upper part must be placed outside the lower part. Do not connect the
cooker hood exhaust to the same conductor used to circulate hot air or
for evacuating fumes from other appliances generated by other than
an electrical source. Before proceeding with the assembly operations,
remove the anti-grease filter(s) so that the unit is easier to handle.
- In the case of assembly of the appliance in the suction version prepare
the hole for evacuation of the air.
• We recommend the use of an air exhaust tube which has the same
diameter as the air exhaust outlet hole. If a pipe with a smaller diameter
is used, the efficiency of the product may be reduced and its operation
may become noisier.

INSTALLATION

Procedure for fixing
• Dimensional Drawings.
• Fix the hood as shown in the scheme.
Connecting and fitting
• Before connecting the appliance, check the household installation.
Appliance with prefitted power cable: The power cable must only be replaced by a trained after-sa-
les engineer. Installing: Do not trap the power cable and do not route it over sharp edges. If the oven
is a built-under type, route the cable on the rear corners of the oven to the socket.
Eletrical Connection
This is a class I, appliance and must therefore be connected to an effiecient earthing system.
- The appliance must be connected to the electricity supply as follows:
BROWN = L line
BLUE = N neutral
YELLOW/GREEN = earth.
The neutral wire must be connected to the terminal with the N symbol while the YELLOW/GREEN,
wire must be connected to the terminal by the earth symbol .
When connecting the appliance to the electricity supply, make sure that the mains socket has an
earth connection. After fitting the ducted cooker hood, make sure that the electrical plug is in a po-
sition where it can be accessed easily. If the appliance is connected directly to the electricity supply,
an omnipolar switch with a minimum contact opening of 3 mm must be placed in between the two;
its size must be suitable for the load required and it must comply with current legislation.
4