TP-Link Archer C9 Manual

Hide thumbs Also See for Archer C9:

Download this manual

Set up Access Point Mode for TP-Link Archer C9

1. Equipment setting

1.1. Connect Wireless to device

1.2. Wireless –turn off main modem

1.3. Connect LAN cable from main modem to Internet port behind AP TP-Link Archer C9

1.4. Turn on main modem

1.5. Turn on AP TP-Link Archer C9

Remarks:

because AP TP-Link Archer C9 has set Access Point mode from the factory. If

correctly connected, it'll be ready to use immediately. To check the settings as following

steps:

Page 1 1. Equipment setting 1.1. Connect Wireless to device 1.2. Wireless –turn off main modem 1.3. Connect LAN cable from main modem to Internet port behind AP TP-Link Archer C9 1.4. Turn on main modem 1.5. Turn on AP TP-Link Archer C9 Remarks: because AP TP-Link Archer C9 has set Access Point mode from the factory.
Page 2 2. Check the settings : type 192.168.0.1 in the Address bar on Browser then press Enter, type Username = admin, Password = admin and press Login...
Page 3 3. Quick Setup 3.1. Region and Time zone  Region : can’t change  Time zone : select Bangkok, Jakarta, Hanoi  Once completed, press Next 3.2. WAN Connection Type  Select Dynamic IP and press Next...
Page 4 3.3. Select Do NOT clone Mac Address then press Next...
Page 5 3.4. Wireless Settings  Wireless 2.4GHz, 5GHz : select ON  Network Name(SSID) : enter name as desired  Password : set password using 8 characters up (for Wireless Quick Setup, it’ll be encrypted by WPA/WPA2 Personal)  Once completed, press Next...
Page 6 3.5. Summary  It’s the summary of settings that we selected, press Save...
Page 7 3.6. Test Your Connection  Press Test Internet Connection , Detecting process for a while then Success  Press Finish...
Page 8 3.7. After Quick Setup, screen will return to Network Map...