Secure Digital Cards - Cisco UCS B420 M3 Installation And Service Note

Step 2
Grasp the front of the blade server and place your other hand under the blade to support it.
Figure 5: Positioning a Blade Server in the Chassis
Step 3
Open the ejector levers in the front of the blade server.
Step 4 Gently slide the blade into the blade slot opening until you cannot push it any farther.
Step 5 Press the ejector levers so that they latch with the edge of the chassis and press the blade server all the way in.
Step 6 Tighten the captive screw on the front of the blade to no more than 3 inch pounds of torque. Tightening with bare fingers
will prevent stripped or damaged captive screws.

Secure Digital Cards

Secure Digital (SD) card slots are provided and one or two SD cards can be populated. If two SD cards are populated, they can be
used in a mirrored mode.
Do not mix different capacity cards in the same server.
Note
10