Power Supply Of The Encoder; Figure 5: Encoder Supply Screen - HEIDENHAIN PWT 101 User Manual

Basic operation | Power supply of the encoder
2.10

Power supply of the encoder

Power displays the current status of the power supply between the product and
the connected encoder.
Display
Tap Power to open the Encoder supply screen.
The Encoder supply screen displays the status and measured values of the power
supply between the product and the connected encoder.

Figure 5: Encoder supply screen

Activating or deactivating the terminating resistor
You can activate or deactivate the terminating resistor on the product depending
on the interface. The availability of a terminating resistor depends on the
respective interface.
If you deactivate the terminating resistor, you can read off the typical current
consumption of encoders. Switching the terminating resistors leads to temporary
activation/deactivation. When you close the Encoder supply screen again, the
status of the terminating resistor is reset.
HEIDENHAIN | PWT 101 Block Commutation Module | User's Manual | 07/2021
Function
Power supply between the product and the connected
encoder is active
Power supply between the product and the connected
encoder is inactive
Tap Power
The Encoder supply screen is opened
Tap Terminating resistor
The product shows the status and the current change in the
table
2
17