Signs On The Crane; Maximum Load - Jonsered 1188S CE Operator's Manual

Particular installations can be quieter, in which case a post installation noise measurement in
accordance with clause 6.3 of EN 12999:2011 may be used to prove this.

3.4. Signs on the crane

XXXXXXX XXXX XX
MAX
xxxxxxxxxx
TYPE
SERIAL NO
MANUF. YEAR
Cargotec Sweden AB
SE-824 83 HUDIKSVALL SWEDEN
SAE 80W/90
T YT T ST Ä Ä Ä Ä
P FYLLNING Å
MAX
FILLING
EINF LLUNG Ü
REMPLISSAGE
MIN
NOTE
The signs may vary depending on the country. Always make sure that you comply
with the statutory requirements of the country in which you use the crane.

3.5. Maximum load

Lifting capacity
Your crane has a certain lifting capacity, expressed in kNm or tm. This lifting capacity is also known
as the load moment. The lifting capacity is: the payload multiplied by the outreach in metres that
the crane can operate at different positions. The lifting capacity of your crane determines the
maximum load your crane may lift within its working zone. However take careful note; the greater
the operating radius of the crane, the lower the lifting capacity will be because of the weight of the
boom system itself. The load plate and the load diagram on your crane show the maximum loads
you may lift in the operating reach of your crane.
DANGER
Overloading could result in damage to the crane or in the worst case, personal
injury or death.
NOTE
The extra weight of the lifting accessories has to be added to the load. Thus, with
lifting accessories the load you can lift is less heavy.
Safety precautions and warnings
XXXX XXXX XXXX XXXX XXXX
XXXX kg
X X X X X X,X m
xxx-xxxx
Jonsered 1188S CE
C F
B E
A D
XXX kN
xxx xxxx
23