Black & Decker 90544326 Instruction Manual page 42

ATTACHING BLADE GUARD AND SPLITTER
ASSEMBLY
DISCONNECT MACHINE FROM POWER SOURCE.
PROPERLY ALIGN THE BLADE GUARD AND SPLITTER ASSEMBLY WITH
THE SAW BLADE TO PREVENT KICKBACK.
1. Position the blade 90 degrees to the table and lock in place.
2. Fasten the splitter support bracket (A) Fig. 9 to the splitter bracket (B) using two 1/4-20x1/2"
hex head screws (C) and two 1/4" external tooth lockwashers (D).
NOTE: Loosely tighten the screws for further adjustment.
3. Locate the 1/4-20x2-1/4" hex head screw (G) Fig. 10. Place the 1/4" internal tooth lockwasher
(O) M6.4 flat washer (P) and the 1/4" external tooth lockwasher (R) on the screw (G).
4. Position the recessed end (E) Fig. 11 of the splitter bracket (B) against the end of the pivot rod
(F), and fasten using the assembly in STEP 3.
NOTE: Loosely tighten the hardware for further adjustment.
5. Position the splitter (H) Fig. 13 against the splitter support bracket, making certain the two
protrusions (K) on the splitter support bracket are inside the slot of splitter (H).
A
C
Fig. 9
R
Fig. 10
Fig. 11
Fig. 12
Fig. 13
42
B
D
P
O
G
F
E
B
G
H
K