Setup Procedure - Honeywell T775A Series Installation Instructions Manual

Fig. 35. Program - Exit.
2.SETUP (ADVANCED OPTIONS)
Setup provides the ability to change the factory default
settings for the temperature sensors and outputs, to
enable/disable reset control, and to enable/disable
scheduling.
NOTE: The controller interface is intuitive. You may
find that you do not need the following setup
instructions for the sensors and outputs. You
may want to use this procedure simply as a
reference to locate the particular option or
parameter of interest.
NOTES:
If you press the HOME button or there is no
1.
keypad activity for four minutes, you exit
Setup mode and return to the home screen.
If you press the MENU button, you exit Setup
2.
mode and return to the menu.

Setup Procedure

The Setup process uses a hierarchical menu structure
that is easy to use. You press the
to move forward and backward through the menus.
NOTE: The menus can display only those relays that
are defined in Setup (see "2.3.2. NBR OF
RELAYS" on page 24). For example, if you
configure only two relays, then only two
relays display on the appropriate menus.
SETUP
SENSORS
Fig. 36. Setup - Sensors Menu.
All manuals and user guides at all-guides.com
T775A/B/M SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLERS
1.2.7. Exiting Program Mode
MENU
Press the HOME button to leave programming mode and
PROGRAM
return to the home screen.
MOD 1
MOD 2
This completes the programming procedure.
RELAY 1
RELAY 2
RELAY 3
RELAY 4
EXIT
M24499
Once in Setup mode, you use the —
• Left arrow button (
Setup menus
• Right arrow button (
item and display its content
• Up and Down arrow buttons (
and down through a list of items or to increase or
decrease the value of a displayed setup parameter
To change the controller's sensors and output setup
parameters, perform the following procedures in the order
listed:
1. Enter Setup mode — see "2.1. Entering Setup
2. Setup Sensors — see "2.2. Setting up the Sensors"
3. Setup Outputs — see "2.3. Setting up the Outputs"
4. Exit Setup Mode — see "2.4. EXIT Setup Mode" on
2.1. Entering Setup Mode
and arrow buttons
To enter Setup mode, press and hold the MENU button for
five seconds to display the Setup menu. Refer to Fig. 27
on page 13.
2.2. Setting up the Sensors
SETUP
SENSORS
1. From the Setup menu, use the
# SENSORS
SENSOR A
2. Press the
SENSOR B
EXIT
M24500
17
) to scroll backward through the
) to select the highlighted menu
Mode"
on page 21
page 30
to highlight SENSORS.
button to display the Sensors menu.
and ) to scroll up
and buttons
62-0254—13