Check Rotating Floor Brush/Drive Belt; Cleaning Post-Motor Filter - Bissell 6584 Series User Manual

M
aintenance and care

Cleaning post-motor filter

Use only bISSEll Style 10 replacement filters in
your bISSEll Powerforce bagless.
1.
Unplug the cleaner from electrical outlet.
2.
The post-motor filter assists in the filtration
process to return clean air to the room. It is
located behind the door on the front of the
cleaner. When the filter becomes dirty, open
the door, remove the filter and clean.
3.
The post-motor filter may be hand washed
in warm water. Mild detergent may be used
if desired. Rinse well, then air dry thoroughly
before replacing.
4.
Replace the door by inserting the tabs on the left
side and snapping the right side into place.
Check rotating floor brush and drive belt
you should check your vacuum cleaner's rotating
floor brush and drive belt regularly for wear or
damage. you should also clean the brush and brush
ends of string, hair, and carpet fibers. These can wrap
around the brush and hamper its ability to effectively
clean your carpet. Also remove any debris that has
accumulated under the brush cover.
1.
Unplug cleaner from electrical outlet.
2.
Place handle in low position and turn vacuum
cleaner over so bottom side is up.
3. Remove the four screws as shown with a Phillips
head screwdriver. Lift the brush cover off.
4.
Grasp rotating floor brush at both ends and lift.
5.
Clean strings, hair and other debris from
rotating floor brush, paying particular attention
to brush ends.
6. Clean strings, hair and other debris from motor
pulley and drive belt areas.
7. Check drive belt carefully for wear, cuts or
stressed areas. Replace if worn.
8.
Check air passageway for obstructions. Remove
debris from this area.
10
w w w . b i s s e l l . c o m
Post-Motor Filter
WARnInG:
To reduce the risk of
injury from moving parts,
turn off vacuum cleaner
and disconnect Power
Plug from electrical outlet.
Motor
Pulley
Air Passageway
Brush
Cover
8 0 0 . 2 3 7 . 7 6 9 1