Operating Tips; Typical Full Load Sizes - Whirlpool GCAM2792TQ2 Installation Instructions Manual

Commercial washer 120-volt, 60-hz
Table of Contents

Advertisement

Available languages

Available languages

Typical full load sizes.

Additional features
WARNING
Load
Loading
Type
Suggestion
Mixed
3 double sheets
Load
4 pillowcases
6 pair shorts
8
T
s -
2
s
i h
2 blouses
Electrical Shock Hazard
8 handkerchiefs
Disconnect power before making
electrical connections.
Permanent
2 double or
Failure to do so can result in death
Press
1 king size sheet
or electrical shock.
1
a t
b
1
d
e r
For WARM RINSE:
1
b
o l
• Remove screws from each end of
2 slacks
the console bottom.
3 shirts
• Pull the console bottom forward;
2 pillowcases
lift and tilt back.
• Connect J1 to J2
To SAVE WATER:

Operating Tips

• Locate water level switch on
back of washer. (See Back Page.)
WARNING
• Turn shaft 45° counterclockwise.
Check list for washer
operation
Check the following if the washer is
not operating properly:
1. Power supply cord is plugged in.
Fire Hazard
2. Circuit breaker is not tripped or fuse
Never place items in the washer
blown.
that are dampened with gasoline or
3. Timer has been advanced to start
other flammable fluids.
of a cycle.
No washer can completely remove
4. Water faucets are turned on.
oil.
5. Inlet and drain hoses are not
Do not dry anything that has ever
kinked.
had any type of oil on it (including
6. Washer lid is closed.
cooking oils).
7. Inlet valve is frozen if not sheltered
Doing so can result in death,
from the weather.
explosion, or fire.
8. Suds level. Excess suds will slow the
spin and cause poor rinsing.
Operate the washer through a
It is recommended that fiberglass
complete cycle with no detergent.
items not be washed in coin-
Use less detergent or a controlled
operated washers. If these items are
suds type detergent in future loads.
washed in the washer, run the washer
through a complete cycle to rinse
If you need
any residue away that might be left in
assistance...
the washer.
The Whirlpool Laundry Trade Partner
Support Center will answer any questions
about operating or maintaining your
washer not covered in the Installation
Instructions. The Whirlpool Laundry Trade
Partner Support Center is available by
dialing 1-800-NO BELTS (1-800-662-3587) —
the call is free.
When you call, you will need the
washer model number and serial
number. Both numbers can be found
on the serial-rating plate located on
your appliance.
PAGE 6
Typical full load sizes.
Load
Type
WARNING:
when using your washer, follow basic precautions, including the following:
Heavy
Mixed
work
• Read all instructions before using
Load
clothes
the washer.
i h
s t r
• Do not wash articles that have
s t r
been previously cleaned in,
washed in, soaked in, or spotted
with gasoline, dry-cleaning
solvents, other flammable or
explosive substances as they give
Knits
off vapors that could ignite or
Permanent
explode.
Press
e l
c
o l
h t
• Do not add gasoline, dry-cleaning
s s
solvents, or other flammable or
u
e s
explosive substances to the wash
water. These substances give off
vapors that could ignite or
explode.
• Under certain conditions,
hydrogen gas may be produced in
Moving the washer to
a hot water system that has not
Operating Tips
been used for 2 weeks or more.
a new location...
HYDROGEN GAS IS EXPLOSIVE. If
the hot water system has not been
used for such a period, before
using a washing machine, turn on
all hot water faucets and let the
water flow from each for several
minutes. This will release any
accumulated hydrogen gas. As
the gas is flammable, do not
smoke or use an open flame
during this time.
Never place items in the washer
that are dampened with gasoline or
Tape rear
legs in "up"
other flammable fluids.
position.
No washer can completely remove
oil.
Do not dry anything that has ever
had any type of oil on it (including
cooking oils).
Doing so can result in death,
explosion, or fire.
It is recommended that fiberglass
items not be washed in coin-
• Remove the front legs from the
operated washers. If these items are
base of the washer.
washed in the washer, run the washer
• Place both rear leveling legs in the
through a complete cycle to rinse
any residue away that might be left in
upper position and tape securely.
the washer.
• Apply tape to the side and bottom
of the cabinet near the rear.
• Open washer lid, wedge a blanket
between the tub ring and the
cabinet top restricting the tub
movement.
• Handle washer gently. Do Not
drop washer while using hand truck.
IMPORTANT SAFETY INSTRUCTIONS
Loading
Load
Loading
Suggestion
To reduce the risk of fire, electric shock, or injury to persons
Type
Suggestion
3 pair pants
3 double sheets
3 shirts
4 pillowcases
1 coverall
6 pair shorts
4
p
a
r i
e j
a
s n
8
T
s -
i h
s t r
1
o
v
e
a r
l l
2
s
i h
s t r
2 blouses
8 handkerchiefs
3 blouses
2 double or
4 slacks
1 king size sheet
6
s
i h
s t r
1
a t
b
e l
c
4
o t
p
s
1
d
e r
s s
4
d
e r
s s
s e
1
b
o l
u
e s
2 slacks
3 shirts
2 pillowcases
WARNING
Wedge blanket
between tub ring
and cabinet top.
Remove front legs.
Fire Hazard
SAVE THESE INSTRUCTIONS
Tape 2
sides.
Note: Do Not
place blanket
in this area
(switch).
Load
Type
Heavy
• Do not allow children to play on or
work
in the washer. Close supervision of
clothes
children is neceassary when the
washer is used near children.
• Before the washer is removed from
service or discarded, remove the
lid.
• Do not reach into the washer if the
Knits
tub or agitator is moving.
• Do not install or store this washer
o l
h t
where it will be exposed to the
weather.
• Do not tamper with controls.
• Do not repair or replace any part
of the washer or attempt any
servicing unless specifically
recommended in the Owner's
Manual or in published user-repair
instructions that you understand
Moving the washer to
and have the skills to carry out.
a new location...
• See Page 3 of this booklet for
recommended grounding
instructions.
Tape rear
Tape 2
legs in "up"
sides.
position.
Note: Do Not
place blanket
in this area
(switch).
• Remove the front legs from the
base of the washer.
• Place both rear leveling legs in the
upper position and tape securely.
• Apply tape to the side and bottom
of the cabinet near the rear.
• Open washer lid, wedge a blanket
between the tub ring and the
cabinet top restricting the tub
movement.
• Handle washer gently. Do Not
drop washer while using hand truck.
Loading
Suggestion
3 pair pants
3 shirts
1 coverall
4
p
a
r i
e j
a
s n
1
o
v
e
a r
l l
3 blouses
4 slacks
6
s
i h
s t r
4
o t
p
s
4
d
e r
s s
s e
Wedge blanket
between tub ring
and cabinet top.
Remove front legs.
PAGE 7

Advertisement

Table of Contents
loading

Table of Contents