RCA ANT115 Installation Instructions

VHF/UHF Antenna Installation
Getting Started
Installation kit contents:
•
A/B Switch
o two screws
o one double-sided tape
•
Coaxial cable jumper with F-connectors
•
RCA ANT115 Indoor Antenna with instructions
Unpacking and setting up RCA ANT115 Indoor Antenna
1.
Remove the RCA ANT115 Indoor Antenna and instructions from package.
2.
Install the retractable VHF dipole and UHF loop antenna as shown in Steps 1 and 2.
Note: Do not complete Step 3 listed on RCA ANT115 Indoor Antenna instructions
sheet.
3.
The A/B Switch can be mounted by using the double sided tape or screws.
4.
Choose the most appropriate configuration from following installations A, B C or D.
A. Installing TV with one RF input port and no set-top-box
1.
Connect the RCA ANT115 coaxial cable F-connector to the A/B Switch "CABLE A"
port.
2.
Disconnect the coaxial cable connected to the TV set "VHF/UHF" input RF port
(some older sets may be marked with "Cable or Antenna") and connect it to the A/B
Switch "CABLE B" port.
3.
Connect one end of the coaxial cable jumper to the A/B Switch "TV" port.
4.
Connect other end of the coaxial cable jumper to the TV set "VHF/UHF" RF input
port.
Caution: All F-connectors must be finger tightened
VHF/UHF ANTENNA
!
INPUT INPUT
VHF/UHF VHF/UHF
VIDEO VIDEO
R R
AUDIO AUDIO
L L
TV SET
CATV INPUT
FROM WA
CABLE B CABLE B
CABLE A CABLE A TV TV
OUTLET
A A A B B B
A/B SWITCH
LL