Audiovox XAPH1 User Manual page 20

Home Installation
The Indoor/Outdoor Home Antenna's reception can also be tweaked by opening
or closing the antenna clamshell, and turning the antenna . While observing the
signal strength, make small adjustments to the angle of tilt of the clamshell until
the highest possible signal strength is achieved . If you have not wall-mounted
the antenna, turn the antenna slightly to the right or left and observe if the
signal strength increases . For each tweak, allow a few seconds in each position to
determine if the signal strength increases .
If the signal reception is good, but there is no audio, verify your audio connection .
• If you are connected to a stereo system, be sure the stereo system is set
to the same AUX In or LINE In audio input source you chose and that
the Stereo Audio Cable is fully connected . If you still have no audio, try
choosing a different input source .
• If you are connected to powered speakers, be sure the speakers are
plugged into an outlet, and are turned On .
20
SOUTH