Table of Contents
Advertisement
Chapter 3 Bluetooth
3.1 Establishing Bluetooth
To establish a Bluetooth
equipment), configure the Bluetooth
Setting*.
®
Bluetooth
adapter as slave (default)
®
The Bluetooth
adapter is a slave by default. This slave can establish a Bluetooth
some other Bluetooth
®
Bluetooth
adapter as master
To use the scanner (or some other Bluetooth
specify the slave's Bluetooth
connection ratio of the Bluetooth
Note: The scanner is automatically connected to the communication adapter via the SPP profile. The scanner
cannot be connected to the communication adapter using the HID profile.
* Registered users can download the device drivers and the configuration software "BA Setting" from QBdirect, their
customer support section on the Denso Wave website at no extra charge.
For further details on QBdirect or to register, visit the following URL.
http://www.qbdirect.net
Wireless Communication
Wireless Link
wireless link between the Bluetooth
®
adapter as a slave (default) or master with the configuration software BA
equipment as a master without special communication procedures.
address to the Bluetooth
®
adapter and slave device should be 1:1.
®
adapter and the scanner (or some other Bluetooth
equipment) as a slave, configure the Bluetooth
®
adapter with the configuration software "BA Setting*". The
8
wireless link with the scanner or
®
adapter as a master and
Advertisement
Table of Contents
