Table of Contents
Advertisement
English
mark) is lowered at the same time as the depth
gauge of the cutter.
WARNING
The rest of the humped drive link must not be
filed; otherwise, this could increase the tendency
of the chain saw to kick back.
► Rework the depth gauge so that it is flush with
the file gauge
► Afterwards, dress the leading edge of the
depth gauge parallel to the service mark (see
arrow) – when doing this, be careful not to fur‐
ther lower the highest point of the depth gauge
WARNING
Depth gauges that are too low increase the kick‐
back tendency of the chain saw.
34
26 Maintaining and Sharpening the Saw Chain
► Lay the file gauge on the saw chain – the high‐
est point of the depth gauge must be flush with
the file gauge
► After sharpening, clean the saw chain thor‐
oughly, removing any filings or grinding dust –
lubricate the saw chain thoroughly
► In the event of extended periods of disuse,
store saw chains in cleaned and oiled condi‐
tion
0458-212-0121-C
Advertisement
Table of Contents
