Ball Check Valve Repair - Graco Husky 2150 Instructions-Parts List Manual

Ball Check Valve Repair

Tools Required
D Torque wrench
D 10 mm socket wrench
D O-ring pick
Disassembly
NOTE: A Fluid Section Repair Kit is available. Refer to
page 21 to order the correct kit for your pump. Parts
included in the kit are marked with an asterisk, for
example (201*). Use all the parts in the kit for the best
results.
NOTE: To ensure proper seating of the balls (301),
always replace the seats (201) when replacing the
balls.
NOTE: (Extension Version) To ensure proper sealing
of extension (115), always replace o–rings (116) when
replacing the balls.
1. Follow the Pressure Relief Procedure Warning
on page 9. Disconnect all hoses.
2. Remove the pump from its mounting.
3. Using a 10 mm socket wrench, remove the four
bolts (106) holding the outlet manifold (103) to the
fluid covers (101). See Fig. 10.
4. Remove the seats (201), balls (301), and o-rings
(202) from the manifold.
NOTE: Some models do not use o-rings (202).
5. Turn the pump over and remove the inlet manifold
(102). Remove the seats (201), balls (301), and
o-rings (202) from the fluid covers (101).
Reassembly
1. Clean all parts and inspect for wear or damage.
Replace parts as needed.
2. Reassemble in the reverse order, following all
notes in Fig. 10. Be sure the ball checks are
assembled exactly as shown. The arrows (A) on
the fluid covers (101) must point toward the outlet
manifold (103).
14 308368
Service
Apply medium-strength (blue) LoctiteR or equivalent
1
to the threads. Torque to 120 to 150 in-lb
(14 to 17 N.m).
2
Arrow (A) must point toward outlet manifold (103).
3
Not used on some models.
4
Beveled seating surface must face ball (301).
Used on stainless steel model only.
5
Fig. 10
Z117
Extension
Models Only
103
1
106
103
*301
101
*201
4
3 *202
106
1
*301
*201
*202
Z115
Z116
TI2233A
101
5
113
A
2
301*
4
201*
202*
3
102
TI0352B