DANGER - To reduce the risk of electrocution: Do not place or store this appliance where it can fall or be pulled into a bath or sink. Do not place in or drop into water or other liquid. 1219876-KR01-C Kohler Co.
Page 3
Use this appliance only for its intended purpose as described in the manual. Do not use attachments not recommended by Kohler Co. Do not lean on seat cover when using product. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped, damaged, or dropped into water.
Seat Slow close Maximum fan 0.19m /min air flow Maximum heater 200W Dryer Five-speed adjustable Temperature (Room temperature to 39 ) adjustment Thermal fuse, heating Safety element thermal cut-out devices Maximum fan Deodorizer 0.19m /min air flow 1219876-KR01-C Kohler Co.
Page 5
All information in this manual is based upon the latest product information available at the time of publication. At Kohler, we constantly strive to improve the quality of our products. We reserve the right to make changes in product characteristics, packaging or availability at any time without notice.
(with a short tone), the night light will be controlled automatically by the environment light (if the environment is dark, the light will be turned on, otherwise it will be turned off). 1219876-KR01-C Kohler Co.
Page 7
FRONT WASH button. It will stop automatically after 300 seconds of continuous flushing. F - Pulsate+Oscillate In the flush state, press this button to activate pulsating flush. Kohler Co. 1219876-KR01-C...
Page 9
When the unit is used for the first time, the following has been preset. Front Wash: Seat temperature: mid Dryer temperature: mid Water Temperature: mid Night light: on Water Pressure: mid Power save: off Position: mid Rear Wash: Water Temperature: mid Water Pressure: mid Position: mid Kohler Co. 1219876-KR01-C...
Page 10
1/3 from the front of the seat (sensor area). Proceed to the “Keypad and Panel Diagram” and “Operation” Sections to test the various seat functions. 1219876-KR01-C Kohler Co.
Care and Cleaning For best results, keep the following in mind when caring for your Kohler product: IMPORTANT! Do not immerse product in water. Test First - Always test your cleaning solution on an inconspicuous area before applying it to the entire surface.
Page 12
After having the bidet wand cleaned, press and hold the BIDET WAND button for over 2 seconds, the bidet wand will retract. Otherwise, the bidet wand will automatically retract after a while. 1219876-KR01-C Kohler Co.
Reinstall the screen. Take care to face right in position to the thread. Reconnect the water supply hose to the seat. Check all connections for leaks and make any adjustments as needed. Turn on the water supply. Kohler Co. 1219876-KR01-C...
Page 14
Otherwise, it may be damaged. Unload the jalousie. Pull out the original deodorization block. Replace with a new one. Load the jalousie. Make sure no impurities in the deodorization assembly before renewing the deodorization block. 1219876-KR01-C Kohler Co.
Page 15
Disconnect the water supply hose from the T-valve. Press the release button(see illustration). Slide the seat forward to disengage the seat front the mounting plate. NOTE: The seat will contain water until drained. Refer to the “Drain the water from the seat” section. Kohler Co. 1219876-KR01-C...
Drain the water from the seat. Reinstall the drain plug. Troubleshooting This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale distributor.
E. Thermal protector to open E. Allow the seat to cool to room automatically to protect. temperature. F. None of the above actions F. Contact a KOHLER Service correct the symptom. Representative. 2. Seat is loose A. Screws and nuts are loose.
Page 18
Probable Causes Recommended Action 15. The seat moves both A. Tighten the bolts of A. The bolts for the mounting plate up and down and right mounting plate. that secure the main unit are and left. loose. 1219876-KR01-C Kohler Co.
1185019-SP Service Parts Installation Screw K-4107KR Attachment 1102014-SP Clip Attachment 1186587-SP 1194769-SP Cable of LED CUSHION assy. night lamp 1184968-SP 1185014-SP-* Cover Bumper LID, COVER assy. 1185018-SP 1183663-SP 1184962-SP-* Mounting Plate Nozzle Gen Assy. DE Back Assy 1185012-SP Deodorizer Assy.
This warranty only applies to the plumbing product purchased and installed in countries/regions as listed below. If a defect is found in normal residential use, Kohler will, at its election, repair, replace or make appropriate adjustment where Kohler inspection...
Page 21
Philippines, Malaysia, No.158, Jiang Chang San Road, Zhabei District, Indonesia, Vietnam, Shanghai, PRC Post Code: 200436 South Korea, Brunei Tel: +(86) 21 2606 2572 and Japan, Fax: +(86) 21 6107 8900 This is Kohler's exclusive written warranty. Kohler Co. 1219876-KR01-C...
Page 22
220~240V AC 50/60Hz 10A 1219876-KR01-C Kohler Co.
Page 48
한번 신장되고, 조작부 램프가 켜지고, 야간 조명이 반짝이면 초기화가 완료된 것입니다. 초기화 과정에서 모터 회전 소리와 물 소리가 들리는 현상은 모두 정상 작동입니다. 처음 사용시의 설정 상태 : 비데: 변좌온도:중급 위치:중급 건조온도:중급 수압:중급 야간조명:On 수온:중급 에너지 절약 모드:Off 세정: 위치:중급 수압:중급 수온:중급 1219876-KR01-C Kohler Co.
Page 49
비닐로 변좌 시트를 감싸고 테스트를 진행하여, 제품에 물이 튀는 것을 방지합니다. 비데는 착좌 센서로 작동하며, 테스트하기 위해서는 먼저 손 혹은 젖은 수건으로 시트의 오른쪽으로부터 앞부분의 1/3되는 곳(감지영역)에 놓습니다. 조작부와 사용방법을 참조하여 각각의 기능을 테스트합니다. Kohler Co. 1219876-KR01-C...
Page 50
중요! 물로 비데를 직접 씻지 마십시오. 1219876-KR01-C Kohler Co.
Page 53
제품 측면에 있는 필터를 분리합니다. 손으로 탈취 블록을 밖으로 빼냅니다. 탈취 블록을 새 것으로 교체합니다. 필터를 재설치 합니다. 탈취 블록을 새로 설치하기 전에 이물질이 탈취 조립부에 끼지 않도록 확인해야 하며, 만약 있다면 제품의 앞부분을 들어서 빠져 나오게 합니다. Kohler Co. 1219876-KR01-C...
Page 54
입수 밸브를 잠급니다. 비데의 세정기능을 작동하여 급수관의 압력을 줄입니다. 전원 플러그를 뽑습니다. 급수관과 T-밸브를 분리 합니다. 분리 버튼을 누릅니다.(그림참조) 비데를 앞으로 이동시켜, 비데와 고정플레이트를 분리 시킵니다. 주의: 비데에 물이 있을 수 있으므로 “비데의 배수”를 참고하여, 깨끗하게 배출 되었는지를 확인합니다. 1219876-KR01-C Kohler Co.
Page 57
소프트 커버 착좌 센서 건조 기능 탈취 기능 기타 Kohler Co. 1219876-KR01-C...
Page 58
1185019-SP Service Parts Installation Screw K-4107KR Attachment 1102014-SP Clip Attachment 1186587-SP 1194769-SP Cable of LED CUSHION assy. night lamp 1184968-SP 1185014-SP-* Cover Bumper LID, COVER assy. 1185018-SP 1183663-SP 1184962-SP-* Mounting Plate Nozzle Gen Assy. DE Back Assy 1185012-SP Deodorizer Assy.
Page 59
This warranty only applies to the plumbing product purchased and installed in countries/regions as listed below. If a defect is found in normal residential use, Kohler will, at its election, repair, replace or make appropriate adjustment where Kohler inspection...
Page 60
Philippines, Malaysia, No.158, Jiang Chang San Road, Zhabei District, Indonesia, Vietnam, Shanghai, PRC Post Code: 200436 South Korea, Brunei Tel: +(86) 21 2606 2572 and Japan, Fax: +(86) 21 6107 8900 This is Kohler's exclusive written warranty. 1219876-KR01-C Kohler Co.
Page 61
220~240V AC 50/60Hz 10A Kohler Co. 1219876-KR01-C...