Advertisement
(5) Motor housing
(6) Dust container
(7) Extension tube
(8) Crevice nozzle
(9) Brush
(10) Holder for crevice nozzle/brush
(11) Floor nozzle
A)
(12) Battery release button
A)
(13) Flexible extension tube
(14) Coarse dirt filter
(15) Housing wall on the coarse dirt filter
(16) Fine dust filter
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical data
Cordless dry vacuum
cleaner
Article number
Container volume (gross)
Max. vacuum (turbine)
Max. flow rate (turbine)
m
Weight according to EPTA-
Procedure 01:2014
Permitted ambient temperature
– while charging
A)
– during operation
and dur-
ing storage
Recommended batteries
Recommended chargers
A) Limited performance at temperatures < 0 °C
Technical data determined using the battery that comes with the
product.
Fitting
Charging the battery
Use only the chargers listed on the accessories page.
u
Only these chargers are compatible with the lithium-ion
battery in your vacuum cleaner.
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your power tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the Electronic Cell Protection (ECP). A protective circuit
Bosch Power Tools
switches the cordless dust extractor off when the battery is
drained.
The battery must be removed from the vacuum cleaner to
charge it.
u
The battery features NTC temperature monitoring, which
only permits charging in a temperature range between 0 °C
and 45 °C. This achieves a long battery life.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.
Battery charge indicator
When the on/off switch (2) is pressed in completely, the bat-
tery charge indicator (3) indicates the battery's state of
charge for several seconds. The indicator consists of three
green LEDs.
LED
UniversalVac 18
Continuous lighting 3 x green
Continuous lighting 2 x green
3 603 CB9 1..
Continuous lighting 1 x green
l
0.5
Slowly flashing light 1 x green
kPa
8.8
3
/min
1.7
Inserting and Removing the Battery
kg
1.3
u
°C
0 to +45
– Insert the charged battery (4) into the vacuum cleaner
°C
–20 to +50
– To remove the battery (4), press the release button (12)
PBA 18V....V-.
PBA 18V....W-.
AL 22.. CV
AL 18.. CV
Fitting the vacuum cleaner accessories (see
figure B)
u
The vacuum cleaner accessories can be directly connected
with the dust container (6).
See the illustration for the different ways of combining the
vacuum cleaner accessories.
– Insert the individual vacuum cleaner accessories firmly
Operation
u
Do not continue to press the on/off button after the
vacuum cleaner has automatically switched itself off.
This can damage the battery.
Do not use force to insert the battery. The battery is de-
signed in such a way that it can only be inserted into the
vacuum cleaner when it is in the right position.
until you feel it engage and it is securely locked in place.
on the battery and pull it out of the vacuum cleaner as
shown in the image (see figure A). Do not use force to do
this.
Remove the battery before cleaning or performing
maintenance on the dust extractor, making tool ad-
justments, changing accessories or placing the dust
extractor in storage. This safety measure prevents the
dust extractor from being started accidentally.
into the connection on the dust container (6) and into one
another.
Remove the battery before cleaning or performing
maintenance on the dust extractor, making tool ad-
1 609 92A 4E4 | (13.08.2018)
English | 7
Capacity
≥ 66%
33–66%
11–33%
≤ 10%
Advertisement
