CCTV COLOR MONITOR SMC-210/210N/210P (21-INCH) SMC-144/144N/144P (14-INCH) SMC-142/142N/142P (14-INCH) SMC-140/140N/140P (14-INCH) SMC-102/102N/102P (10-INCH) SMC-100/100N/100P (10-INCH) SMP-152/152N/152P (15-INCH) SMP-150/150N/150P (15-INCH) SERVICE Manual CCTV COLOR MONITOR CONTENTS 1. Precautions 2. Alignment and Adjustment 3. Exploded View and Parts List 4. Electrical Parts List 5.
1. Precautions Follow these safety,servicing and ESD precautions to prevent damage and protect against potential hazards such as electrical shock and X-rays. 1-1 Safety Precautions 1) Be sure that all of the built-in protective devices are 5) With the unit completely reassembled, plug the AC replaced.
Page 3
Precautions 10) Design Alteration Warning: 16) Picture Tube Implosion Warning: Never alter or add to the mechanical or electrical The picture tube in this receiver employs “inte- design of this unit. Example:Do not add auxiliary gral implosion” protection. To ensure continued audio or video connectors Such alterations might implosion protection, make sure that the replace- create a safety hazard.
Page 4
Precautions 1-2 Servicing Precautions Warning 1 : First read the “Safety Precautions”section of this manual. If some unforeseen circumstance creates a conflict between the servicing and safety precautions, always follow the safety precautions. Warning 2 : An electrolytic capacitor installed with the wrong polarity might explode. 1) Servicing precautions are printed on the cabinet.
2. Alignment and Adjustment 2-1 Measuring Instruments Œ Lion Head Pattern Generator. ´ Color Bar, White, Cross Pattern Generator. ˇ Color Analyzer. ¨ Oscilloscope Scope. 2-2 Connection Status and Aging Œ Input Color Bar in CAMERA 1 (Video A). ´ Input Lion Head in CAMERA 2 (Video B). ˇ...
Page 6
Alignment and Adjustment 2-5-1 Adjustment Mode Set the data as table using control key. MAIN ADJUSTMENT PARAMETER FUNCTION RANGE ADJUST DATA REMARK SUB BRIGHT 0 ~ 13 STEP SUB CONTRAST 0 ~ 13 STEP SUB COLOR 0 ~ 23 STEP S-CORRECTION 0 ~ 63 STEP RED CUTOFF...
Page 7
Alignment and Adjustment 2-6 White Balance Adjustment 2-6-1 High-Light Adjustment Œ Input Lion Head and White Pattern. ´ Aging over 30 minutes. ˇ Check a data in factory mode. ¨ Cheak whether RG, GG and BG are 31 or not. ˆ...
Page 8
Alignment and Adjustment Ø Adjust NVS until the display is located at horizontal center. HORIZONTAL CENTER 525 LINE ∏ Adjust H-Size (LW01) at Main Board until the right and left of the display to be 5. (SMP-152/150 Only) 525 LINE RE.