Getting Started; Assembling Your Steam And Scrub Mop - Shark S6002 Series Instructions Manual

GETTING STARTED

When assembling your steam mop there may be a little water in or around the water tank.
This is because we test all our steam mops before you buy them, so you get a quality
Shark® Steam and Scrub Mop.
A
E
B
C
F
D
A Steam Mop Handle
B Quick-Release Cord Holder
C Steam Mop Body
D Floor head
33
sh a rkclea n.eu
G
H
E Water Tank Lid
F Mode Button
G Dirt Grip Pads
H Filling Flask

ASSEMBLING YOUR STEAM AND SCRUB MOP

1 Insert the mop handle into the steam
mop body until it clicks into place.
3 To open the water tank, pull the lid down.
1.
2 To attach the Dirt Grip pads, place
BOTH the pads flat on the floor with
the plastic rings facing up. Align the
indentation on the rotating discs on the
bottom of the nozzle with the plastic
rings on the pads, then gently lower the
nozzle onto the pads, pressing until the
pads are secured.
3
4 Use the filling flask to pour distilled water
into the tank. Make sure to not exceed the
Max Fill line on the flask. When finished,
close the tank lid firmly.
NOTE: Max capacity of the water tank is 320ml
s ha rkc l ea n.eu
2
4
34