Installation Instructions; Parts Required - Raymarine M81120 Installation Manual

All manuals and user guides at all-guides.com
Hydraulic Pump - Installation Guide
Type 3 pump
Figure 3: Type 3 pump dimensions

Installation instructions

Parts required

To install this drive you will need:
• Parts supplied:
• Additional parts:
Note: Make sure you have obtained these additional parts before you
start installation.
235 mm (9.25 in)
• hydraulic pump
1
• if required: in BSP to
/
4
• suitable hydraulic pipes, hydraulic fluid, T-pieces, pipe
fittings and thread-sealing compound (see page 8)
• suitable securing bolts and lock washers/lock nuts (see
page 8)
• suitable cable and electrical connectors for the drive motor
and clutch (see page 13)
All ports are 1/4 inch BSP (parallel threaded)
holes to accept 6 mm (0.25 in) bolts
117 mm (4.62 in)
1
in NPT adaptors (x3)
/
4
5
D5173-1