Sharp LC-20SH6U Service Manual page 25

5. On Setting Items
* "EZ-SETUP" discussed below indicates "EZ-SETUP after the first power-on".
(1) POWER ON FIXED
Selection Selection between
Default – (Variable)
"
Explanation In Fixed
received. The power can be turned off by stopping the power supply from AC.
Limit in Setting Refer to the
Exception None
Remarks Selection of
•
"
In Variable
•
switch is off.
Display ON/OFF in hotel menu is controlled by adjustment process
•
(2) MAXIMUM VOLUME
Selection Adjustment from 0 to 60 (no loop)
Default 60
Explanation Sound volume can not be adjusted higher than the preset value.
Limit in Setting When the sound volume is set lower than 59, only figures are displayed and the sound volume bar is not
•
displayed.
The maximum sound volume for ON-timer (Wake up timer) is limited also to the preset value.
•
Exception In the item
•
setting.
Remarks In line output (sound volume variable), the sound volume can be adjusted from -60 to 0 irrespective of pre-
•
adjusted value.
When the sound volume is set higher than the MAX setting by the adjusting process, the sound volume
•
control operation is prohibited for turn-up and the sound volume should be turned down to MAX in this
state.
(3) VOLUME FIXED
Selection Selection between "Variable" and "Fixed" (loop provided)
Default Variable
Explanation Sound volume is fixed and made invariable.
Limit in Setting The sound volume for the ON-timer (Wake up timer) is fixed also without display of menu. Besides, the
•
setting is made impossible. (Basically, the menu is not displayed.)
The following keys become invalid:
•
Sound volume Up/Down (VOL +/-) [for both remote control and the unit]
•
Mute (MUTE)
•
Exception In the item "VOLUME" of adjustment process, the sound volume can be set freely irrespective of this
•
setting.
Remarks In line output (sound volume variable), the sound volume can be adjusted from -60 to 0 irrespective of pre-
•
adjusted value.
As for sound volume fixing and sound volume MAX level, the sound volume fixing has priority.
•
Once the sound volume has been changed by adjustment process, it should be set back to the sound
•
volume preset by sound volume fixing level when the adjustment process ends .
" " "
Variable and Fixed
"
setting, the power-off by the power key of the unit is invalidated and the image is kept being
" "
Power-On Fixed sheet.
" "
FIXED depends on use of STB etc.
"
setting, the power operation is in wait for 1 sec. and then turned off when the main power
" "
VOLUME of adjustment process, the sound volume can be set freely irrespective of this
"
(loop provided)
25
LC-20SH6U
" "
HOTEL POWERFIX .