Configuring Device B; Verifying The Configuration; Configuration Files - H3C S6800 Configuration Examples

[DeviceA-Ten-GigabitEthernet1/0/1] quit
# Configure Ten-GigabitEthernet 1/0/2 as a trunk port, assign it to VLAN 1000, and remove it from
VLAN 1.
[DeviceA] interface ten-gigabitethernet 1/0/2
[DeviceA-Ten-GigabitEthernet1/0/2] port link-type trunk
[DeviceA-Ten-GigabitEthernet1/0/2] port trunk permit vlan 1000
[DeviceA-Ten-GigabitEthernet1/0/2] undo port trunk permit vlan 1
[DeviceA-Ten-GigabitEthernet1/0/2] quit

Configuring Device B

# Configure Device B in the same way Device A is configured. (Details not shown.)

Verifying the configuration

# Verify that correct PBB VSI uplink connections have been established between BEB 1 and BEB 2.
<BEB1> display pbb connection
BMAC
011e-8300-0001
0cda-415e-232e
<BEB2> display pbb connection
BMAC
011e-8300-0001
00e0-fc58-1234
# Verify that hosts in Site 1 and Site 2 can ping each another. (Details not shown.)
# Verify that the BCB does not learn customer MAC addresses.
<BCB> display mac-address

Configuration files

•
BEB 1 and BEB 2:
#
vlan 1000
#
vlan 2000
#
l2vpn enable
#
vsi test
pbb i-sid 1
bvlan 2000
encapsulation ethernet
#
interface Ten-GigabitEthernet1/0/1
port link-mode bridge
port link-type trunk
undo port trunk permit vlan 1
BVLAN Port
2000 XGE1/0/1
2000 XGE1/0/1
BVLAN Port
2000 XGE1/0/1
2000 XGE1/0/1
Type Aging
MC N
UC Y
Type Aging
MC N
UC Y
4