Table of Contents
Advertisement
Using the Product Recovery CD-ROMs
You can only use these Recovery
CD-ROMs on the Sony notebook
you purchased and not on any
other Sony PC or other
manufacturer's PC!
To perform a system recovery,
the notebook should not be
docked (port replicator).
For more information about
using your CD-ROM drive, read
the corresponding chapter in this
user guide or the manual
supplied with your peripheral.
Using the Product Recovery CD-ROMs
The following sections describe how to use the Recovery CD-ROMs.
You will find a set of two Recovery CD-ROMs in your Product Recovery Pack:
The System Recovery CD-ROM (vol. 1 of 2) and System Recovery CD-ROM
(vol. 2 of 2).
The system recovery process allows you to reinstall an image of the hard disk as it was
when you started using your notebook computer.
Use the System Recovery CD in the following cases:
In the event of a serious system crash,
If you want to modify the size of your partitions,
Reinstall an individual driver if a device is not functioning properly.
!
Applying a system recovery means that you will lose all your data stored on your C: drive (and your D: drive if
you modify partition settings).
!
CAUTION: make sure that your computer is connected to AC (not the batteries) before you attempt a system
recovery.
!
CAUTION: when the recovery is performed, you must remove the recovery CD-ROM from the drive before
restarting the computer. If the CD-ROM is still in the drive, you will restart a recovery process.
The recovery process takes between 10 to 20 minutes to complete.
39
n N
Advertisement
Table of Contents
