DeLonghi EW7707CM Instructions For Use page 3

plug. Do not use the outlet and CALL your electrician.
20. Check that neither the appliance nor the power cable have been damaged
in any way during transportation.
21. Make sure that no pieces of polystyrene or other packaging material have
been left between one element of the appliance and another. It may be
necessary to pass over the appliance with a vacuum cleaner.
22. When switching on the appliance for the first time, allow it to run at full
power for about two hours to get rid of the unpleasant smell Make sure
that the room in which the appliance is located is well ventilated during
this operation. It is normal for the appliance to emit small cracking sounds
when you turn it on for the first time.
23. Do not use an extension cord because it may overheat and cause a risk of
fire. However, if you have to use an extension cord, the cord shall be No.
14 AWG minimum size and rated not less than 1875 watts, and has to be
used only for supplying power to this heater.
24. Do not cover the appliance while it is functioning in order to avoid overhea-
ting with the attendant risk of fire.
SAVE THESE INSTRUCTIONS
For Household use only
HOW TO USE YOUR HEATER
"EASY WHEEL"SYSTEM
Turn the radiator upside-down on a rug or
a soft surface in order to prevent dama-
ging the paint finish. Fully unfold the
castors by turning them outwards (Fig. 4).
Turn the radiator back to its upright posi-
tion.
CAUTION
Always operate the heater in upright posi-
tion only (wheels on the bottom, controls
on top). Any other position could create
hazardous situation!
WATTS ECONOMIZER
For more economical use, the two switches
may be used individually, after unit has
reached the operating temperature.
With pilot lights ON, the heater is ON!
Your product is equipped with a polari-
zed alternating current line plug (a plug
having one blade wider than the other).
fig. 4
There is only one way it can be plugged
into a power supply. This is a safety fea-
ture. If you are unable to insert the plug
fully into the outlet, try again by turning it
the other way. If it would still not go in, it
is probably due to an obsolete outlet
which should be replaced. Do not tamper
with the plug or outlet to defeat the pur-
pose of this safety mechanism.
3