Table of Contents
Advertisement
33. Insert the Pad Tube (29) into the Front Leg (7).
Slide two Small Foam Pads (28) onto the ends of
the Pad Tube. Then, press two Pad Caps (34)
into the Foam Pads.
Slide two Small Foam Pads (28) onto the Leg
Lever (8). Then, press two Pad Caps (34) into the
Small Foam Pads.
34. Attach the Curl Pad (14) to the Curl Post (13) with
two M6 x 16mm Screws (62).
35. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on page 18.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
around the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT:
If the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAM on page 21 for proper cable routing. If there is any slack in the cables, you will
need to remove the slack by tightening the cables. See MAINTENANCE on page 22.
All manuals and user guides at all-guides.com
17
33
34
28
7
34
28
28
8
34
14
29
28
34
34
62
13
Advertisement
Table of Contents
