Sony Handycam DCR-HC16E Operation Manual page 70

4
Touch (pause) again at the point
where you want to start recording the
sound.
The playback pauses.
5
Touch and select [PAGE3].
6
Touch [A DUB CTRL].
60min 0:00:00:00
A DUB CTRL
AUDIO
7
Touch [AUDIO DUB].
X mark appears on the LCD
A green
screen.
60min 60min 0:00:00:00 0:00:00:00
A DUB CTRL
AUDIO
8
Touch (play) and start playing
back the audio you want to record at
the same time.
A red mark remains on the LCD screen
while recording sound.
The new sound is recorded in stereo 2
([ST2]) during the playback of the tape.
9
Touch (stop) when you want to
stop recording.
To dub on other scenes, repeat steps 3 and 4
to select scenes, then touch [AUDIO DUB].
10
Touch [ RET.], then
To set the end point for audio dubbing
For DCR-HC18E/HC20E:
During playback, press ZERO SET MEMORY
on the Remote Commander at the scene at
70
Dubbing/Editing
RET.
DUB
RET.
DUB
.
which you want to stop audio dubbing. Then,
perform steps 4 to 8. The recording stops
automatically at the selected scene.
b Note
• You can only record additional audio over a tape
recorded on your camcorder. The sound may
deteriorate when you dub audio on a tape recorded
on other camcorders (including other DCR-HC16E/
HC18E/HC20E camcorders).
Checking and adjusting the
recorded sound
1
Play back the tape on which you have
recorded audio in "Recording sound"
(p. 69).
2
Touch to display [PAGE1].
3
Touch MENU.
4
Select (PLAYER SET) for DCR-
HC16E/HC18E, or
for DCR-HC20E, then select [AUDIO
MIX] with
[EXEC].
VCR SET
HiFi SOUND
AUDIO MIX
ST1 ST2
EXEC RET.
5
Touch /
balance between the original sound
([ST1]) and the sound added
afterwards ([ST2]). Then, touch
[EXEC].
The original sound ([ST1]) is output in the
default setting.
The adjusted audio balance returns to the
default setting in about 5 minutes after the
(VCR SET)
/ , then touch
to adjust the