Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Vax Rapide Match XL V-027CC
Summary of Contents for Vax Rapide Match XL V-027CC
- Page 1 All manuals and user guides at all-guides.com Vax careline 0870 6061248 Carpet washer Vax model number: V-027CC SOLUTION Please read carefully before using this cleaner. www.vax.co.uk Always fully extend the mains cable before use. Retain for future reference.
-
Page 2: Parts Overview
27 Upholstery/stair wash tool 8 Dirty water tank nozzle tab 18 Carry handle 28 Solution spray trigger 9 Dirty water tank latch 19 Cord 29 Vax AAA Solution Dirty water tank handle 20 Lower cord and hose storage parts overview... -
Page 3: Safety Information
Do not use with a damaged cord or plug. If the supply cord and/or plug is damaged, they must be replaced PLEASE KEEP THESE INSTRUCTIONS by the manufacturer, a Vax Service Agent or similarly FOR FURTHER USE. qualified persons in order to avoid hazard. - Page 4 All manuals and user guides at all-guides.com www.vax.co.uk 3. Assembly Feed the cord through the slots on the back of the handle and push into place (Fig.3/4). Putting your cleaner together Remove your Rapide XL from the carton with caution.
- Page 5 All manuals and user guides at all-guides.com Vax Careline 0870 606 1248 Clean water tank Slide the tool caddy downwards until it is secured in place (Fig.3/10). NOTE: Make sure the grey wedge block is resting in place (fig.3/7). NOTE: The tool caddy can be removed for storage on a wall Fig.3/7...
-
Page 6: Operation
Once the float is activated, empty the dirty water Fig.4/3 tank. Note: Use only Vax AAA Solution. using other If the tank does not appear full turn off the power cleaning solution may cause excessive foaming. This switch and wait for the float to settle. For best may cause the float to shut off the cleaner results use only Vax AAA Solution. - Page 7 All manuals and user guides at all-guides.com Vax Careline 0870 606 1248 To spray cleaning solution, depress the solution release trigger (Fig 4/6) and move the cleaner backward and forward. Release the trigger and push the unit back and forth in the same track to remove dirty water and solution from the carpet.
- Page 8 All manuals and user guides at all-guides.com www.vax.co.uk To wash upholstery, be sure that the brush switch is OFF and that the power and soap switches are turned ON (Fig.4/13). Note: Do not allow upholstery to become too wet. Fig.4/16 Move the tool/floor selector to the floor position (downwards) (Fig.4/17).
- Page 9 All manuals and user guides at all-guides.com Vax Careline 0870 606 1248 Emptying the dirty water tank Depress the dirty water tank latch and simultaneously pull the dirty water tank nozzle tab up and away from the cleaner (Fig.4/8). Fig.4/11 Return the dirty water tank cap (Fig.4/12).
-
Page 10: Maintenance
All manuals and user guides at all-guides.com www.vax.co.uk 5. Maintenance Emptying the dirty water tank Return dirty water tank to the base of the cleaner by Remove dirty water tank and front nozzle put them to tipping the nozzle down into the basin and dropping it one side (Fig.5/1). - Page 11 All manuals and user guides at all-guides.com Vax Careline 0870 606 1248 NOTE: Make sure the entire belt stays on top of the first large pulley by lightly placing a finder on top to guide it. Fig.5/7 To install a new brushbar. Feed the brushbar through the Fig.5/4...
- Page 12 All manuals and user guides at all-guides.com EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the Vax V-027CC is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste.