Installation - Electrolux SC320 User Manual

12 www.electrolux.com
Problem
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
Upper or lower
square is shown in
the temperature
Display.
dEMo appears on
the Display.
The buzzer sounds.
The Display is red.
7.1 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
7.2 Closing the door
1. Clean the door gaskets.

8. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
Possible cause
Products prevent that wa-
ter flows into the water col-
lector.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
An error has occurred in
measuring the tempera-
ture.
The appliance is in demon-
stration mode (dEMo).
The door is not closed cor-
rectly.
2.
3.
the climate class indicated on the rating
plate of the appliance:
Solution
Make sure that products do
not touch the rear plate.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but tempera-
ture adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. the OK button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
Refer to "Door open alarm".
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.