Table of Contents
Advertisement
6-2 Apron & Saddle
1. Apron lubrication location: On the right top side of the saddle, the oil inlet plug
marked "OIL" is the oil inlet hole.
2. Apron drain hole is located on the bottom cover of the apron.
3. Oil brand and oil exchange time: Use Shell Tellus #32 and replace the oil every 6
months.
4. To adjust the half nut engaged lever: After long period of usage, the lever may
become loose and needed to be adjusted. First, please take off the thread chasing
dial and find the 4 gib adjusting screws. Second, while pressing the lever, also
adjust the 4 gib adjusting screws until they are properly tightened. Afterwards,
please re-install the thread chasing dial in position.
5. Adjustment for the longitudinal & cross auto feeding overload:
Please stop the machine before doing adjustment. The cone clutch on the right
hand side of the apron is an overload protection device. Turning clockwise, the
overload will increase; turning anticlockwise, the overload will decrease.
6-3 Gear Box
1. Lubrication location: Below the top cover of the gear box, please take off the top
cover to find the oil plug marking "OIL", which is the oil inlet hole.
2. Drain hole: On the left bottom side of the 10-step feed selection dial. The screw
with hexagon nut is the oil drain hole .
3. Oil brand and oil replacement time: Use Shell Tellus Omala 150 and replace the
oil every 6 months.
29
Advertisement
Table of Contents
