Using Your Radio - Cobra MICROTALK CXT225C Manual

CXT225C_MANL_ENG:PR270-C_Eng 12/3/09 2:52 PM Page 2

Using Your Radio

Operation
Speaker/Microphone/Charge Jack
To attach a speaker/microphone:
Speaker/Microphone/
Charge Jack 1. Open the speaker/microphone/charge
tab on top of your microTALK
2. Insert the speaker/microphone accessory
plug into the speaker/microphone/charge jack.
To connect a wall charger/adapter:
1. Open the speaker/microphone/charge
tab on top of your microTALK
2. Insert the wall charger/adapter plug
into the speaker/microphone/charge jack.
Quick Start
1. Press and hold the Mode/Power button
to turn on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
Turning on Your microTALK
Press and hold the Mode/Power button until you
Mode/Power
hear a series of audible tones indicating the radio
is on.
Your microTALK
ready to receive transmissions. The radio is
always in Standby mode except when the Talk,
Call or Mode/Power buttons are pressed.
English
2
All manuals and user guides at all-guides.com
radio.
®
® radio.
Both radios must be tuned to the same
channel/privacy code to communicate.
® Radio
radio is now in Standby mode,
®
Introduction
Battery Low
•
Battery Low
Auto Battery Save
Battery Save Mode
Communicating with Another Person
Talk Button
Two Inches (5 cm)
from Mouth
To Select a Channel
Channel Button
•
Channel Number
Operation Customer Assistance
When battery power is low, the Battery Low icon
will blink. Your batteries should be replaced or
recharged, if using rechargeable batteries.
If there are no transmissions within 10 seconds,
the radio will automatically switch to Battery
Save mode and the Power Saver icon will flash
in the display. This will not affect the radio's
ability to receive incoming transmissions.
1. Press and hold the Talk button.
2. With the microphone about two inches
(5 cm) from your mouth, speak in a
normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to the same
channel/privacy code to communicate.
With the radio on, select any of the
22 channels by pressing the Channel Up
or Channel Down button.
Both radios must be tuned to the same
channel/privacy code to communicate.
Channels 1 through 7 are shared with FRS/
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 14 for FRS/GMRS frequency
allocations and compatibility charts.
Nothing Comes Close to a Cobra
Warranty
•
•
•
•
® 3