Honeywell HS-0016 Owner's Manual page 5

GRILLE ASSEMBLY INSTRUCTIONS
• Remove the Rear Grille
Mounting Nut (G) from the
Motor. Place the Rear
Grille (H) onto the Motor
Housing, making sure the
three holes of the Rear
Grille fit over the three
matching bumps on the
Motor Housing. Tighten the
Rear Grille Mounting Nut
CLOCKWISE (Fig. 3).
• Push the Fan Blade (I) onto
the Motor Shafts (J) lining
up the center of the blade
with the D-Shape on the
Motor Shaft. Tighten the
Blade Knob (K) by turning
it COUNTER CLOCKWISE
(Fig. 4).
• Using a Phillips-head
screwdriver, loosen the
screw on the Grille Ring
slightly, just enough to
relieve the tension
(Fig. 5).
• Place the Front Grille over
the Rear Grille by hooking
the tab located on the top
of the Front Grille over the
top of the Rear Grille (Fig.
6). Snap the Grille Ring into
place.
• Tighten the screw on the
Grille Ring.
Fig. 3
G
J
Fig. 4
K
I
Fig. 5
Fig. 6
H