Specifying The Speaker Parameters - Sony STR-DE495 Operating Instructions Manual

Multi channel surround setup
(continued)
When placing surround speakers behind you
C
Note
Do not place the center speaker further away from the
listening position than the front speakers.
Normal Speaker and Micro
Satellite Speaker
If you are using
Normal Speakers
Micro Satellite Speakers
The speaker size and the sub woofer selection
has been preset to "NORM. SP.". You can
adjust the speaker size and sub woofer
selection when you select "NORM. SP." (page
17).
To select "MICRO SP.", turn off the power,
then turn on again while pressing MAIN
MENU. (To reset to "NORM. SP.", do the
same procedure.)
When you select "MICRO SP.", the speaker
size and sub woofer selection has been
configurated as follows:
Speaker
FRONT
CENTER
SURROUND
SUB WOOFER
You cannot change the configuration if you select
"MICRO SP.".
GB
16
(wide room)
B
A A
45°
C
90°
20°
Select
NORM. SP.
MICRO SP.
Settings
SMALL
SMALL
SMALL
YES
Tip
The setting for Micro Satellite Speaker (MICRO SP.)
has been programmed to optimize the sound balance.
If you use Sony's Micro Satellite Speakers, select
"MICRO SP.".
Caution
When you use Micro Satellite Speakers and the
speaker size is set to "LARGE", you may not obtain
the correct soundstage. The speaker may also be
damaged at high volume position.
Specifying the speaker
parameters
1
Press MAIN MENU repeatedly to select
" SET UP ".
2
Press MENU or MENU
the parameter you want to adjust.
3
Press MENU + or MENU – to select the
setting you want.
The setting is entered automatically.
4
Repeat steps 2 and 3 until you have set
all of the parameters that follow.
Initial settings
Parameter
(SUB WOOFER) S.W. XXX
SW
(FRONT) XXXXX
R
L
(CENTER) XXXXX
C
(SURROUND) XXXXX
SL SR
DIST. X.X m (XX ft.)**
L R
DIST. X.X m (XX ft.)**
C
DIST. X.X m (XX ft.)**
SL SR
PL. XXXX
SL SR
* You can set this parameter only when you select
"NORM. SP.".
** The default unit for models of area code U, CA is
"ft.".
The default unit for models of other area code is
"m".
to select
Initial setting
YES*
LARGE*
LARGE*
LARGE*
3.0 m (10 ft.)**
3.0 m (10 ft.)**
3.0 m (10 ft.)**
LOW